1998 JAGUAR X308 Workshop Manual

power steeringoil resetradiatorwindowengine coolantdiagnostic menu
Popular search:
distributorbrake light switchtrunkremove seatsdiagnostic menufront axlebumper
Previous
Next
Load previous 8 pages

Page 177 of 2490

JAGUAR X308 1998 2.G Workshop Manual Inst all new inner mounting bracket bolts. Ti ghten to 88-118 Nm. 8. NOTE : Right-hand shown, left-hand similar Tighten to 88-118 Nm. 9. NOTE : Right-hand shown, left-hand similar

Page 178 of 2490

JAGUAR X308 1998 2.G Workshop Manual 13. Inst all the exhaust brackets. Position exha ust mounting bracket on subframe. Inst al l bolts and nuts. Tigh te n to 22-28 Nm. 14 . Route the left hand parking brake c

Page 179 of 2490

JAGUAR X308 1998 2.G Workshop Manual 18 . Install the brake caliper on to the carrier. 1. Position the caliper asse mbly on to the carrier. 2. Install the guide pins and tighten to 25-30 Nm. 3. Install the dust caps. 4. Install

Page 180 of 2490

JAGUAR X308 1998 2.G Workshop Manual Rear Su spension - Rear Shock Absorber Re mo val and Installation Remov a l S p ecial Tool(s) Spri ng C ompressors 204-179 (JD 199) Spri ng Re taining straps 204-179-1 (JD 199-1) 1. CA

Page 181 of 2490

JAGUAR X308 1998 2.G Workshop Manual 5. Remove an d discard the tie st rap securing the wheel speed sensor harness to the brake hose clip. 6. Mark the wi shbone at the pivot pin eccentric flange marker to aid installation.

Page 182 of 2490

JAGUAR X308 1998 2.G Workshop Manual Withdraw th e hub carrier and support on a block of wood. 9. CAUTIO N: Note the position of the shims during removal. They must be returned to th eir original position during installatio

Page 183 of 2490

JAGUAR X308 1998 2.G Workshop Manual 13 . Using the special tools 204-179-1, secure the upper mounting to the spring. 14 . Using a jack, retract the shock absorber through the wishbone aperture. 15 . Position a bolt thr

Page 184 of 2490

JAGUAR X308 1998 2.G Workshop Manual 18. Lower and remove the jack. 19. Remove the shock absorber an d spring assembly from the vehicle and place the assembly on a work bench. 20. Clean the upper mounting spring location. 21
Load next 8 pages
Page:   < prev 1-10 ... 145-152 153-160 161-168 169-176 177-184 185-192 193-200 201-208 209-216 ... 2496 next >
refuellinghomelinkfuel additivesalarmfusesoctane
Popular search:
clockfuel leveltow barvalve clearancewiper fluidtire pressuregas tank size