1998 JAGUAR X308 Workshop Manual

radio controlswiringair bleedingnight visionCD changermileage
Popular search:
troubleshootinginflation pressureSpeed Sensorcrankshaft position sensorStarter motorgas tank sizeCD player
Previous
Next
Load previous 8 pages

Page 801 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 20. Clean and inspect all relevant components. 1. Push the tensioner piston (secon dary chain) into the body to provide clearance for fitting. 1. Insert a thin rigid wire th rough t

Page 802 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Fit the retaining / pivot bolt and tighten it to 12-16 Nm. 6. Refit the primary chain tensione r assembly. Refer to Operation 12.65.55 in this Section. Use a wedge 303 - 533 (or two if r

Page 803 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Refit the access grommet to the housing. 13. Lower the ramp. 14. Refit the B-Bank VVT Bush Carrier Assembly. Refer to operation 12.65.52 in this Section. 15. Refit the Timing Cover. R

Page 804 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Secondary Timing Chain RH In-vehicle Repair Removal Special Tool(s) Camshaft setting 303-530 Timing chain tensioning 303-532 Wedges, primary chain 303-533 Crankshaft setting

Page 805 of 2490

JAGUAR X308 1998 2.G Workshop Manual 1. Remove the bolt which secures the crankshaft position sensor to the flywheel housing. Remove the sensor and allow it to hang free under the engine. 2. Remove the access grommet (for torqu

Page 806 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 15. Remove the primary ch ain tensioner blade. 1. Remove the pivot bolt which secures the tensioner blade. 2. Remove the tensioner blade. 16. Disconnect the primary chain from the

Page 807 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Fit the chain tensioning tool 303 - 532 to the exhaust camshaft sprocket. Reposition the sprocket (and the VVT unit) for the most advantageous position for use of the tool. Remove t

Page 808 of 2490

JAGUAR X308 1998 2.G Workshop Manual 7. Tighten the exhaust camshaft sprocket securing bolt. 1. Fit the chain tensioner tool 303 - 532 to the sprocket holes. Apply force to the tool in an anti-clockwise direction to tension
Load next 8 pages
Page:   < prev 1-10 ... 769-776 777-784 785-792 793-800 801-808 809-816 817-824 825-832 833-840 ... 2496 next >
fuel additivesdisplayfuel reserveflat tiretowingair suspension
Popular search:
AUTOMATIC19.60.04Starter relaysupercharger removalbrake padstrunkparking brake ORDER BY 80