1998 JAGUAR X308 Workshop Manual

fuse box locationfuse chartfuelseat adjustmenttechnical specificationswheelbase
Popular search:
ECO modeMirrorwiringdistributormaintenanceparking sensorsbank 1
Previous
Next
Load previous 8 pages

Page 553 of 2490

JAGUAR X308 1998 2.G Workshop Manual 1 2.60.48. 12. Install the old bolt which secu red the crankshaft damper, to allow the crankshaft to be rotated. Use a new bolt on final installation. 13. The following group of instructions (un

Page 554 of 2490

JAGUAR X308 1998 2.G Workshop Manual 20. Apply new en gine oil to the co nnecting rod bearing and to the crankpin. 21. Carefull y move the connecting rod and piston assembly towards the the crankshaft and connect it to the cra

Page 555 of 2490

JAGUAR X308 1998 2.G Workshop Manual I nstallation Tigh ten each bolt to 8 to 12 Nm initial torque value. Ti ghten to a final torque of 57 to 63 Nm. 27. Check that the cranks haft turns freely. 28. Repeat the previous o

Page 556 of 2490

JAGUAR X308 1998 2.G Workshop Manual 5. Install the front cros smember. Refer to Operat ion 76.10.05. 6. Install the undert ray. Refer to Operation 76.22.90. 7. Install both front wheel and tyre assemblies. Refer to Operatio

Page 557 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Cr ankshaft Fron t Seal4.0L NA V8 - AJ 27/3.2L NA V8 - AJ26 In-v ehicle Repair Remov al S pecial Tool(s) Cr ankshaft locking, main tool 303-191 Adaptor 303-191-02 Crankshaft

Page 558 of 2490

JAGUAR X308 1998 2.G Workshop Manual Instal l the crankshaft locking tool to the damper. 1. Install adaptor 303-191-02 to the main locking tool 303-191. 2. Reposition the cranks haft/damper to align the mounting holes and install t

Page 559 of 2490

JAGUAR X308 1998 2.G Workshop Manual I nstallation 11 . Remove the crankshaft front seal. 1. Install and tighten the removal tool 303-541 to the crankshaft front seal. 2. Tighten the centre bolt of the tool to extract the seal.

Page 560 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. If the damper is not to be installed immediately, the transit ring should be installed temporarily to the seal. 4. Install a new O-ri ng seal to the damper. 5. Instal l the cranksh
Load next 8 pages
Page:   < prev 1-10 ... 521-528 529-536 537-544 545-552 553-560 561-568 569-576 577-584 585-592 ... 2496 next >
wheel torquefuel reservelow oil pressurefuel filter locationCD changeradblue reset
Popular search:
parking brake ORDER BY 10warning lightlamp bulbHeel boardignitionflat tirecheck engine light