1998 JAGUAR X308 Workshop Manual

wheel boltsfuel pumpcarplayfold seatsinstrument panelrecommended oil
Popular search:
Pas pumpvalveparking sensorsoverheatingHeater hoseignitionregulator torque
Previous
Next
Load previous 8 pages

Page 2249 of 2490

JAGUAR X308 1998 2.G Workshop Manual multiplug. 52. Withdraw in-car sensor from housing and remove housing/trunk release switch assembly. 53. Remove LH vent/duct assembly from facia. Remove two screws securing vent/duct ass

Page 2250 of 2490

JAGUAR X308 1998 2.G Workshop Manual 56. Partially withdraw airbag module, disconnect link harness multiplug and remove airbag from facia. 57. Remove RH vent/duct assembly from facia. Remove two screws securing vent/duct as

Page 2251 of 2490

JAGUAR X308 1998 2.G Workshop Manual Remove clock from centre vent. 61. Reposition facia face down on bench. 62. Withdraw centre defro st vent for access, release solar sensor harness multiplug from retaining cl ip and discon

Page 2252 of 2490

JAGUAR X308 1998 2.G Workshop Manual 66. Remove screws securing LH an d RH face level air ducts to facia and remove ducts. 67. Remove four nuts securing ai r distribution box to facia. 68. Position air distribution box for ac

Page 2253 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 70. Disconnect aspirator harness multiplug and remove aspirator, carefully routing hose through facia aperture. 71. Release facia harness multiplugs from retaining brackets on

Page 2254 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Install solar sensor harness multiplug on LH retaining bracket. 4. Pass solar sensor harness mult iplug through facia aperture. Install solar sensor harness grommet. 5. Install facia harnes

Page 2255 of 2490

JAGUAR X308 1998 2.G Workshop Manual 9. Fully seat air distribution bo x and install securing nuts. 10. Install LH and RH air distributi on box/facia side vent ducts and install securing screws. 11. Install LH and RH top vents

Page 2256 of 2490

JAGUAR X308 1998 2.G Workshop Manual 17. Install centre vent/clock assembly. 1. Install new centre vent retaining screw inserts in facia. 2. Position centre vent/clo ck assembly at facia and connect clock harness multiplug to fa
Load next 8 pages
Page:   < prev 1-10 ... 2217-2224 2225-2232 2233-2240 2241-2248 2249-2256 2257-2264 2265-2272 2273-2280 2281-2288 ... 2496 next >
keyrelayjacking pointsadding oilclockfuel consumption
Popular search:
steeringenginelowerwarning lightsbattery replacementtrunk releaseclimate control