1998 JAGUAR X308 Workshop Manual

open gas tanksuspensionaudiorelaykeylessspark plugs
Popular search:
ignitionpanelaccessory drivePas pumpchange key batteryrefuellingbumper
Previous
Next
Load previous 8 pages

Page 769 of 2490

JAGUAR X308 1998 2.G Workshop Manual 1. Fit the new sealing ring (scarf jointed) to the carrier bush groove. 2. Fit a new O-ring to the carrier oil-way. 22. NOTE: Lubricate the seal (s carf jointed) and the bush. Fit the VVT

Page 770 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Primary Timing Chain LH4.0L SC V8 - AJ26/3.2L NA V8 - AJ26, 3.2L/4.0L In-vehicle Repair Removal Special Tool(s) Camshaft setting 303-530 Timing chain tensioning 303-532 Wedges,

Page 771 of 2490

JAGUAR X308 1998 2.G Workshop Manual position sensor to the flywheel housing. Remove the sensor and allow it to hang free under the engine. 2. Remove the access grommet (for torque converter bolts) from the housing. 7. Instal

Page 772 of 2490

JAGUAR X308 1998 2.G Workshop Manual 14. Loosen the bolt which secures the sprocket to the intake camshaft. 15. Remove the primary ch ain tensioner bolts. 16. Remove the tensioner assembly. 1. Remove the tensioner. 2. Remov

Page 773 of 2490

JAGUAR X308 1998 2.G Workshop Manual 18. Remove the chain from the cams haft sprocket and from the crankshaft sprocket. 19. Remove the camshaft locking tool 303-530 and transfer it to Bank 2 camshafts, aligning the shafts slightl

Page 774 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 23. Remove the tensioner assembly. 1. Remove the tensioner. 2. Remove the tensioner back-plate. 24. Remove the chain tensioner blade. 1. Remove the pivot bolt which secures the

Page 775 of 2490

JAGUAR X308 1998 2.G Workshop Manual camshaft sprocket, Bank 2. Reposition the sprocket to the most advantageous position for use of the tool. Remove the tool. 2. Install the primary timi ng chain, Bank 2. 1. Install the

Page 776 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Whilst applying the opposing force to the sprocket and chain, tighten the sprock et securing bolt to 115- 125 Nm. 6. Tighten the intake camshaft sprocket securing bolt. 1. Whilst still appl
Load next 8 pages
Page:   < prev 1-10 ... 737-744 745-752 753-760 761-768 769-776 777-784 785-792 793-800 801-808 ... 2496 next >
dead batterytrip computerfusehood openemergency towingheadlight bulb
Popular search:
spark plugs replacespeed controlSeat switchbattery capacityrear electric seatsSuperchargerfuel fill door release