1998 JAGUAR X308 Workshop Manual

power steering fluidtow barjump cableload capacitybulbsteering wheel
Popular search:
mirror controlsundertrayFuse boxescrankshaft position sensor testMirrorveneerfilter
Previous
Next
Load previous 8 pages

Page 1585 of 2490

JAGUAR X308 1998 2.G Workshop Manual Connect the scan tool 1 Have the DTC(s) and freeze frame data been recorded? Yes GO to E2 E2: CHECK O2 SENSOR HEATER CONTINUITY Ignition switch to position 0 1 Disconnect EM023 Bracket on

Page 1586 of 2490

JAGUAR X308 1998 2.G Workshop Manual Run the engine for a period to warm the sensor and then maintain a steady speed of approximately 2500 rpm. 1 With EM023 disconnected, measure the voltage between EM023/003 and EM023/004. 2 Is th

Page 1587 of 2490

JAGUAR X308 1998 2.G Workshop Manual With the conditions held as E3, suddenly decelerate to idle. 1 Has the voltage dropped to 400mV or less ? Yes GO to E5 No Renew O2 sensor. Reconnect plug(s) GO to E7 E5: CHECK FOR O2 SENSOR

Page 1588 of 2490

JAGUAR X308 1998 2.G Workshop Manual With the conditions held as E4, suddenly accelerate to approximately 2500 rpm. 1 Has the voltage risen to between 600mV and 1 volt? Yes GO to E7 No Renew O2 sensor; reconnect plug(s) GO to E6

Page 1589 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM023 disconnected measure the insulation resistance between sensor pin 001 and sensor body. 1 Repeat for pin 003 and sensor body. 2 Is the resistance > 10 MOHM? Yes GO to E9 No Renew th

Page 1590 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM010 and EM014 disconnected, measure the resistance between EM010/023 and chassis ground EM008L 1 Is the resistance < 0.5 OHM? Yes GO to E10 No Inspect harness / connector EM010 for cor

Page 1591 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM010 and EM014 disconnected, measure the resistance between EM014/004 and chassis ground EM008L. 1 Is the resistance < 0.5 OHM? Yes GO to E12 No Inspect harness / connector EM014 for co

Page 1592 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM012 and EM023 disconnected, measure the resistance between EM012/014 and EM023/003. 1 Is the resistance < 0.5 OHM? Yes GO to E13 No Inspect harness / connecto rs EM012, and EM023 for cor
Load next 8 pages
Page:   < prev 1-10 ... 1553-1560 1561-1568 1569-1576 1577-1584 1585-1592 1593-1600 1601-1608 1609-1616 1617-1624 ... 2496 next >
coolant reservoirspark plugsrelaycabin filterpark assistseat memory
Popular search:
speedDoor removemanual radio set12.21.14p0420bank 1service reset