1998 JAGUAR X308 Workshop Manual

wiper bladesair suspensioninterior lights4WDalternatorstop start
Popular search:
jacking pointsfront axlePas pumpair suspensionfuse box diagramcruise control fusemuffler
Previous
Next
Load previous 8 pages

Page 889 of 2490

JAGUAR X308 1998 2.G Workshop Manual 7. Tighten the exhaust camshaft sprocket securing bolt. 1. Fit the chain tensioner tool 303 - 532 to the sprocket holes. Apply force to the tool in an anti-clockwise direction to tension

Page 890 of 2490

JAGUAR X308 1998 2.G Workshop Manual 16. Move the engine compartment cover from the service position and connect the gas struts. 17. Remove the paint protection sheets and close the cover. 18. Connect the battery and fit the ba

Page 891 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Variable Camshaft Timing Oil Control Unit Housing LH In-vehicle Repair Removal Installation 1. Open the engine compartment and fit paintwork protection sheets. 2. Set the engine compar

Page 892 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Fit the bush carrier to the cylinder block. Lubricate the seal (scarf jointed) and the bush. 1. Fit the bush carrier assembly. Check that the seals are in pl ace and that the rin

Page 893 of 2490

JAGUAR X308 1998 2.G Workshop Manual V ariable Camshaft Timing Oil Control Unit Housing RH 12.65.51 Removal 1. Open the engine compartment and fit paintwork protection sheets. 2. Set the engine compartment cover to the service access po

Page 894 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Release the carrier from the two ring dowels and remove it. 6. Remove the seals from the bush carrier. 1. Remove the sealing ring (scarf jointed) from the carrier bush groove. 2. Remove the O-ri

Page 895 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2 . Fit the bush carrier to the cylinder block. Lubricate the seal (scarf jointed) and the bush. 1. Fit the bush carrier assembly.  Check that the seals are in place and that the ring dowe

Page 896 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Engine Removal Removal Special Tool(s) Engine Lifting Brackets 303-536 Quick Fit Connector Release Tool 310-044 Quick Fit Connector Release Tool 310-054 Quick Fit Connector R
Load next 8 pages
Page:   < prev 1-10 ... 857-864 865-872 873-880 881-888 889-896 897-904 905-912 913-920 921-928 ... 2496 next >
alarmcatalytic converterbrake pads replacementad bluedashboardrun flat
Popular search:
filtertimingsupercharger removaltrailer303-06water pumpOverflow