1998 JAGUAR X308 Workshop Manual

rear entertainmentclimate settingsjackingsensorfusealternator
Popular search:
head boltSuperchargerlumbar supportoil changelamp bulbbrake sensortow bar
Previous
Next
Load previous 8 pages

Page 1569 of 2490

JAGUAR X308 1998 2.G Workshop Manual Pinpoint test D: P0140 Measure the insulation resistance between EM012/017 and EM012/022. 1 Is the resistance > 10 MOHM? Yes Reconnect all plugs GO to C18 No Inspect harness / connector EM012

Page 1570 of 2490

JAGUAR X308 1998 2.G Workshop Manual Connect the scan tool 1 Have the DTC(s) and freeze frame data been recorded? Yes GO to D2 D2: CHECK FOR LOW EXHAUST TEMPERATURE Check the engine and exhaust system for correct operation and no

Page 1571 of 2490

JAGUAR X308 1998 2.G Workshop Manual Is the voltage between 600mV and 1.0 Volt? Yes GO to D4 No Renew O2 sensor; reconnect plug(s). GO to D7 D4: CHECK FOR O2 SENSOR FAILURE With the conditions held as D3, suddenly decelerate to i

Page 1572 of 2490

JAGUAR X308 1998 2.G Workshop Manual With the conditions held as D4, suddenly accelerate to approximately 2500 rpm. 1 Has the voltage risen to between 600mV and 1 volt? Yes GO to D6 No Renew O2 sensor. Reconnect plug(s). GO to D7

Page 1573 of 2490

JAGUAR X308 1998 2.G Workshop Manual With the conditions held as in D5, run the engine at 1500 rpm for approximately 3 minutes. 1 Does the displayed voltage drop below 400mV and rise above 500 mV, cycling approximately every 180 seco

Page 1574 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM012 and EM022 disconnected, measure the resistance between EM012/017 and EM022/002. 1 Is the resistance < 0.5 OHM Yes GO to D9 No Inspect harness / connectors EM012 and EM022 for corros

Page 1575 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM012 and EM022 disconnected, measure the resistance between EM012/022 and EM022/001. 1 Is the resistance < 0.5 OHM? Yes GO to D10 No Inspect harness / connectors EM012 and EM022 for corr

Page 1576 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM022 disconnected measure the insulation resistance between sensor pin 001 and sensor body. 1 Repeat for pin 002 and sensor body. 2 Is the resistance > 10 MOHM? Yes GO to D12 No Renew t
Load next 8 pages
Page:   < prev 1-10 ... 1537-1544 1545-1552 1553-1560 1561-1568 1569-1576 1577-1584 1585-1592 1593-1600 1601-1608 ... 2496 next >
oil typespare wheelwheel bolt torquewarning lightsfuel pumpspare tire
Popular search:
p1336SOLENOIDservice resetignition switchEngine fuse box diagramparticcheck transmission fluid