1998 JAGUAR X308 Workshop Manual

alternatorsunroofdead batteryairbag offclimate controlservice reset
Popular search:
recommended oilstop startSTARTEREngine generalfuse box locationStarter Motor 86.60.0176.46.03
Previous
Next
Load previous 8 pages

Page 233 of 2490

JAGUAR X308 1998 2.G Workshop Manual 25 . Install hub assembly to wi shbone and axle assembly. Position hu b and carrier to wishbone and axle shaft. Install piv ot pin ensuring that eccentric flange correctly seats in w

Page 234 of 2490

JAGUAR X308 1998 2.G Workshop Manual 29. Tigh ten pivot pin nut. Al ign mark er on pivot pin flange with mark made on wishbone. Ensuri ng pi n position is not disturbed, tighten nut to 88- 118Nm. 30 . Inst all whee

Page 235 of 2490

JAGUAR X308 1998 2.G Workshop Manual 35 . Tighten hub nut to 304-336Nm. 36. Remove securing nuts and withdraw special tool 204-195 from hub. 37. Install rear wheel. Refer to Section 204-04. 38. Remove stands and lower vehi cl

Page 236 of 2490

JAGUAR X308 1998 2.G Workshop Manual 43 . Adjust parkin g brake cable. Refer to 70.35.10. 44. Lower four-post lift 45. Apply parking brake. 46. Carry out rear wheel alignm ent check and adjust as necessary. Refer to data in

Page 237 of 2490

JAGUAR X308 1998 2.G Workshop Manual Rear Suspension - Wheel Hub Seal Re moval and Installation Remov al S pecial Tool(s) Hub Holdin g Tool 204-195 (JD227) Hub Pu ller 204-011 (JD 1D) R ear-Hub Remover 204-113 (JD 132)

Page 238 of 2490

JAGUAR X308 1998 2.G Workshop Manual clip . 5. With draw parkin g brake cable th rough equalizer (LH side cable only). 6. Lower four-post lift. 7. Raise rear of vehicle to workin g height and support on stands. Refer to sect

Page 239 of 2490

JAGUAR X308 1998 2.G Workshop Manual Disc onnect wheel speed sensor harness connector. R emove sensor securing bolt and withdraw sensor from hub carrier. 15 . Sever and discard wheel speed sensor harness tie strap and

Page 240 of 2490

JAGUAR X308 1998 2.G Workshop Manual 19. Remove h ub puller an d thread protector. Re move securing nuts and release puller from hub. Re move thread protecto r from axle shaft. 20 . Relea se parking brake cable from
Load next 8 pages
Page:   < prev 1-10 ... 201-208 209-216 217-224 225-232 233-240 241-248 249-256 257-264 265-272 ... 2496 next >
towingoil temperaturekeylesstrailerbatteryautomatic transmission fluid
Popular search:
crankshaft position sensor testfour wheel drivehigh beamdrive platepark assistEngine fuse box diagramsteering