1998 JAGUAR X308 Workshop Manual

bolt patternchargingwiringfuel additivesinfotainmentadblue
Popular search:
upper steering columnsteering wheelpurge valvebatteryem 022messagebattery replacement
Previous
Next
Load previous 8 pages

Page 593 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Cr ankshaft Pulley4.0L NA V8 - AJ 27/3.2L NA V8 - AJ26 In-v ehicle Repair Remov al S pecial Tool(s) Cr ankshaft locking, main tool 303-191 Adaptor 303-191-02 Crankshaft fron

Page 594 of 2490

JAGUAR X308 1998 2.G Workshop Manual Instal l the crankshaft locking tool to the damper. 1. Install adaptor 303-191-02 to the main locking tool 303-191. 2. Reposition the cranks haft/damper to align the mounting holes and install t

Page 595 of 2490

JAGUAR X308 1998 2.G Workshop Manual I nstallation 11 . Remove the crankshaft front seal. 1. Install and tighten the removal tool 303-541 to the crankshaft front seal. 2. Tighten the centre bolt of the tool to extract the seal.

Page 596 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. If the damper is not to be installed immediately, the transit ring should be installed temporarily to the seal. 4. Install a new O-ri ng seal to the damper. 5. Instal l the cranksh

Page 597 of 2490

JAGUAR X308 1998 2.G Workshop Manual C rankshaft Pulley Vehicles With: Supercharger 12.21.09 Special Service tools C rankshaft locking, main tool 303-191 A daptor 303-191-02 A daptor 303-191-03

Page 598 of 2490

JAGUAR X308 1998 2.G Workshop Manual Cr ankshaft front seal remover 303-541 Cr ankshaft front seal replacer 303-542 Cr ankshaft pulley/damper remover 303-588 Removal 1. Open the engine compartment and fit paintwork protection sheets. 2

Page 599 of 2490

JAGUAR X308 1998 2.G Workshop Manual 5 . Remove the twin fan and motor assembly for access. Refer to Operation 26.25.12 6 . C AUTION: Under no circumstances should the crankshaft setting peg 303-531 be used in the following operation

Page 600 of 2490

JAGUAR X308 1998 2.G Workshop Manual 8. NOTE: The damper only needs to be withdrawn along the crankshaft nose by approximately 2mm before removing the puller. The damper will then either be loose or only require a sharp tap with a mal
Load next 8 pages
Page:   < prev 1-10 ... 561-568 569-576 577-584 585-592 593-600 601-608 609-616 617-624 625-632 ... 2496 next >
headlight bulbtailgatecenter consoleclimate settingsengine coolantbattery replacement
Popular search:
Fuse boxesspark plugs replacecooling systemrelaycomponent locationwheel torqueCD player