1998 JAGUAR X308 Workshop Manual

weightmirrorfuel pressurelightsfuel filtercenter console
Popular search:
oil dipstickfuel filterwipersjack pointscruise control lamptemperature sensorSOLENOID
Previous
Next
Load previous 8 pages

Page 1513 of 2490

JAGUAR X308 1998 2.G Workshop Manual Automatic Transmission/Transaxle External Contro ls - 4.0L SC V8 - AJ26 - Selector Lever Cable and Bracket Removal and Installation Removal 1. Disconnect the vehicle battery ground lead. 2. Pos

Page 1514 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 2. Slacken the outer cable locknuts. 13. Push the outer cable grommet through the transmission tunnel aperture. 14. Remove the selector cable assembly from the vehicle. 1. A

Page 1515 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Secure the outer cable. 4. Adjust the selector cable in accordance with Operation 44.15.07. 5. Further installation is the reve rse of the removal procedure.

Page 1516 of 2490

JAGUAR X308 1998 2.G Workshop Manual Automatic Transmission/Transaxle External Contro ls - 4.0L SC V8 - AJ26 - Selector Lever Gate Finish Panel Removal and Installation Removal Installation 1. Apply protective tape to veneer a

Page 1517 of 2490

JAGUAR X308 1998 2.G Workshop Manual Automatic Transmission/Transaxle External Contro ls - 4.0L SC V8 - AJ26 - Selector Lever Indicator Disc Removal and Installation Removal Installation 1. Disconnect the vehicle battery groun

Page 1518 of 2490

JAGUAR X308 1998 2.G Workshop Manual Automatic Transmission/Transaxle External Contro ls - 4.0L SC V8 - AJ26 - Transmission Control Switch (TCS) Removal and Installation Removal Installation 1. Position the gear selector to N to p

Page 1519 of 2490

JAGUAR X308 1998 2.G Workshop Manual Align the drive peg and lower sliding block of the switch to the mating components of the selector mechanism. 2. Install the four screws, bu t do not fully tighten. Remove the Ty-Strap

Page 1520 of 2490

JAGUAR X308 1998 2.G Workshop Manual moving the set position of either the gear selector lever or the selector lever on the transmission casing. 3. Tighten to 22-28 Nm. 4. Verify the N setting. 6. Check that all released conn
Load next 8 pages
Page:   < prev 1-10 ... 1481-1488 1489-1496 1497-1504 1505-1512 1513-1520 1521-1528 1529-1536 1537-1544 1545-1552 ... 2496 next >
four wheel driveresetfuse box diagramcheck oilwheelbaseoil dipstick
Popular search:
wheel bolt torqueWipesvapourpower steering fluidFuse boxes12.21.14radio