1998 JAGUAR X308 Workshop Manual

fuel filterlow beamtraction controlopen gas tankbulbbrake rotor
Popular search:
dtc codeinterior lightsdriver seat adjustment86.41.33catalytic converterslanguagefog light bulb
Previous
Next
Load previous 8 pages

Page 577 of 2490

JAGUAR X308 1998 2.G Workshop Manual Remove the sensor and allow it to hang free under the engine. 2. Remove the access grommet (for torque converter bolts) from the housing. 7. Install the damper securing bolt (old one) to

Page 578 of 2490

JAGUAR X308 1998 2.G Workshop Manual 14. L oosen the bolt which secures the sprocket to the intake camshaft. 15 . Re move the primary ch ain tensioner bolts. 16 . R emove the tensioner assembly. 1. Remove the tensioner. 2

Page 579 of 2490

JAGUAR X308 1998 2.G Workshop Manual 18 . Remove the chain from the cams haft sprocket and from the crankshaft sprocket. 19 . Remove the camshaft locking tool 303-530 and transfer it to Bank 2 camshafts, aligning the shafts sli

Page 580 of 2490

JAGUAR X308 1998 2.G Workshop Manual 23. R emove the tensioner assembly. 1. Remove the tensioner. 2. Remove the tensioner back-plate. 24. R emove the chain tensioner blade. 1. Remove the pivot bolt which secures the tensione

Page 581 of 2490

JAGUAR X308 1998 2.G Workshop Manual I nstallation 28 . Clean and inspect all relevant components. 1. F it the sprockets to the crankshaft. The teeth of Bank 1 and Bank 2 sprockets on the crankshaft must be out of phas e

Page 582 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Install the retaining / pivo t bolt and tighten it to 12- 16 Nm. 5. Install the primary ch ain te nsioner assembly. Refer to Operation 12.65.55. Use a wedge 3 03-5 33 (or two if requi

Page 583 of 2490

JAGUAR X308 1998 2.G Workshop Manual 9. Inst all the chain tensioning tool 303-532 to the exhaust camshaft sprocket, Bank 1. Re position the sprockets to the most advantageous position for use of the tool. R emove the

Page 584 of 2490

JAGUAR X308 1998 2.G Workshop Manual 13. Tigh ten the exhaust camshaft sprocket securing bolt. 1. Install the chain tensioner tool 303-532 to the sprocket holes. Appl y force to the tool in an anti-clockwise direction to
Load next 8 pages
Page:   < prev 1-10 ... 545-552 553-560 561-568 569-576 577-584 585-592 593-600 601-608 609-616 ... 2496 next >
hood releaseremote start4WDpark assistairbag disablefog light bulb
Popular search:
205-2washer nozzlewinter tiresparking brake ORDER BY 98fog light bulberrorchange key battery