1998 JAGUAR X308 Workshop Manual

oil typenavigation update4WDlane assistheatingtire pressure
Popular search:
messageFront bumperjack pointsfusesjackingmanual radio settorque
Previous
Next
Load previous 8 pages

Page 753 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Tighten the bolts to the correct torque figure 11 - 13 Nm, in the sequence indicated. Tighten the drain plug to 30 - 40 Nm. Fit a new oil filter. 4. NOTE: When the engine is s

Page 754 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Oil Pressure Switch In-vehicle Repair Removal Installation 1. Raise vehicle on four post ramp. 2. Remove oil pressure switch. Disconnect connector. Remove oil pressure swi

Page 755 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Oil Pump4.0L NA V8 - AJ27/3.2L NA V8 - AJ26 In-vehicle Repair Removal Installation 1. Disconnect battery ground cable. Remove the battery cover. 2. Remove the engine compartment

Page 756 of 2490

JAGUAR X308 1998 2.G Workshop Manual inside of the pump gear engage correctly with the mating flats on the crankshaft. 3. Fit the securing bolts and tighten to 11 - 13 Nm. 2. Refit both sprockets to the crankshaft, both primary

Page 757 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Oil Pump4.0L SC V8 - AJ26 In-vehicle Repair Removal Installation 1. Disconnect battery ground cable. Remove the battery cover. 2. Remove the engine compartment cover (bonnet) for

Page 758 of 2490

JAGUAR X308 1998 2.G Workshop Manual the block face; ensure that the drive flats on the inside of the pump gear engage correctly with the mating flats on the crankshaft. 3. Fit the securing bolts and tighten to 11 - 13 Nm. 2.

Page 759 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Primary Timing Chain LH4.0L NA V8 - AJ27 In-vehicle Repair Removal Special Tool(s) Camshaft setting 303 - 530 Timing chain tensioning 303 - 532 Wedges, primary chain 303 - 533

Page 760 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Release the carrier from the two ring dowels and remove it. 6. Remove the seals from the bush carrier. 1. Remove the sealing ring (scarf jointed) from the carrier bush groove. 2. Remove
Load next 8 pages
Page:   < prev 1-10 ... 721-728 729-736 737-744 745-752 753-760 761-768 769-776 777-784 785-792 ... 2496 next >
night visionpower steering fluidbluetoothoil additivestire typeheight adjustment
Popular search:
wiper sizebrake light switchparking brake ORDER BY 90fuel tank removaldistributoroil viscositycheck oil