1998 JAGUAR X308 Workshop Manual

jump cablebattery capacityheatingautomatic transmission fluidwiper sizecheck oil
Popular search:
idle air control valveSteering column boltsnozzlefuel pressurestop startbrake rotordiagram
Previous
Next
Load previous 8 pages

Page 977 of 2490

JAGUAR X308 1998 2.G Workshop Manual conde nser. 2. Fit a new O-ring seal to the pipe. Lubricate the seal with A/C compressor oil. 3. Reconnect the pipe to the condenser and fit the securing bolt. 6. Conne ct the transmission

Page 978 of 2490

JAGUAR X308 1998 2.G Workshop Manual 10. F it the radiator top securing panel. 1. Position and align th e top securing panel. 2. Fit the eight securing bolts to the panel. 11. Tigh ten the ten bolts which secu re the radiator

Page 979 of 2490

JAGUAR X308 1998 2.G Workshop Manual 16 . Refill the cooling system. Refer to the Refill procedure in General Procedures. 17. Repressurise the climate cont rol system. Refer to Section 412-03 Observe all safety warnin gs and pre

Page 980 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine Cooling - Radiator4.0L SC V8 - AJ26 Remo val and Installation Remov a l 1. Op en the engine compartment and fit paintwork protection sheets. 2. Disc onnect the batt ery ground cabl

Page 981 of 2490

JAGUAR X308 1998 2.G Workshop Manual 1. Disconnect and reposition the union nut, upper cooler pipe to radiator. Di sconnect the pipe. 2. Remove and discard the O- ring seal from the pipe and fit blanking plugs to the pipe and to th

Page 982 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Fit blanking plugs to the hose and to the condenser. 14 . Di sconnect the condenser jump hose from the receiver / drier. 1. Remove the bolt which secures the condenser jump hose and disc

Page 983 of 2490

JAGUAR X308 1998 2.G Workshop Manual I nstallation 19 . Remove the fan switch. 1. F it new foam sealing strips to the radiator top, and bottom faces. If removed previously, refit the jump hose to the condenser. 2.

Page 984 of 2490

JAGUAR X308 1998 2.G Workshop Manual conden ser. 2. Fit a new O-ring seal to the pipe. Lubricate the seal with A/C compressor oil. 3. Reconnect the pipe to the condenser and fit the securing bolt. 6. Conne ct the transmission
Load next 8 pages
Page:   < prev 1-10 ... 945-952 953-960 961-968 969-976 977-984 985-992 993-1000 1001-1008 1009-1016 ... 2496 next >
4WDautomatic transmissiontire pressureservicekeyless entryfuel additives
Popular search:
remove oxygen sensorrear electric seatsfuel capAdaptive fuseclutchvalveemergency towing