1998 JAGUAR X308 Workshop Manual

rear entertainmentrefuellingisofixdiagnostic menuoctanespark plugs replace
Popular search:
check oillamp bulbfuel injection and supplylumbar supportdrain boltOverflowRadiator
Previous
Next
Load previous 8 pages

Page 145 of 2490

JAGUAR X308 1998 2.G Workshop Manual 4. NOTE : The gap between the ears of the circlip must be positioned at the lowest point of the bore, when the vertical link is installed on the vehicl e. Refer to General Procedures for furt

Page 146 of 2490

JAGUAR X308 1998 2.G Workshop Manual 8. CAUTIO N: Do not slacken the rotor nut to engage the spring clip. • NOTE: If the castellated slots of the rotor nut are not aligned, tighten the nut until the spring clip engages in t

Page 147 of 2490

JAGUAR X308 1998 2.G Workshop Manual Front Suspension - Wheel Knuckle Re moval and Installation S pecial Tool(s) Hub Remover 204-193 (JD 224) Hub Removal Collets 2 04-194 (JD 225) Hub Holdin g Tool 204-195 (JD 227) H

Page 148 of 2490

JAGUAR X308 1998 2.G Workshop Manual Remova l CAUTI O N: Replacement of nuts and bolts: Various thread-locking devises are used on nuts and bolts throughout the vehicle. These devises restrict the number of times a nut or bolt can b

Page 149 of 2490

JAGUAR X308 1998 2.G Workshop Manual 8. R emove rotor nut. Using speci al tool remove rotor nut. 9. Remove vertical link and hub assembly from special tool. 10 . CAUTION: Removing the hu b from the vertical link damages

Page 150 of 2490

JAGUAR X308 1998 2.G Workshop Manual In stallation Using a hy draulic press, remove wheel bearing from the vertical link. 1. Position the vertical link so that the inboard side of the bearing bore is resting on suit able supports

Page 151 of 2490

JAGUAR X308 1998 2.G Workshop Manual Inst all inboard circli p in vertical link. 5. U sing a hydraulic press, install hub in vertical link. 1. Position special tool on press bed. 2. Position vertical link on the tool, with the i

Page 152 of 2490

JAGUAR X308 1998 2.G Workshop Manual tigh ten the nut until the spring clip engages in the slots. Install rotor nut spring-clip. Inst al l spring clip in hub retaining holes and castellated slots of the rotor nut. 9. In
Load next 8 pages
Page:   < prev 1-10 ... 113-120 121-128 129-136 137-144 145-152 153-160 161-168 169-176 177-184 ... 2496 next >
dead battery open trunkengine overheatlow beamCD changercheck oilrelay
Popular search:
fuel pressureCoolant recoveryAirbag sensorspeedwheelcrankcase position sensorlight