1998 JAGUAR X308 Workshop Manual

lightsbolt patternhandbrakebulbset clockCD changer
Popular search:
remote startfuel injectorheight adjustmenthood openEngine generalparking brake ORDER BY 50radio
Previous
Next
Load previous 8 pages

Page 2449 of 2490

JAGUAR X308 1998 2.G Workshop Manual undertray. Install bolt and tighten to 17-23Nm. 19. Install both front road wheels. Refer to Section 204-04. 20. Raise vehicle, remove st ands and lower vehicle. 21. Remove special t

Page 2450 of 2490

JAGUAR X308 1998 2.G Workshop Manual Uni-Body, Subframe and Mounting System - Front Axle Crossmember Front Bushing Heat Shield Removal and Installation Removal CAUTION: Replacement of nuts and bolts: Various thread-locking devices a

Page 2451 of 2490

JAGUAR X308 1998 2.G Workshop Manual 9. Raise front of vehicle. 10. Remove generator cool ing duct deflector. Remove bolt. Move deflector rearwards to release tangs from undertray. Release deflector from rear vertical

Page 2452 of 2490

JAGUAR X308 1998 2.G Workshop Manual 14. Remove undertray from vehicle. 15. Position camber tie down special tool 204-114 on suspension. Fully slacken tool adjuster nut. Position tool in road spring and pass upper dowel thr

Page 2453 of 2490

JAGUAR X308 1998 2.G Workshop Manual 21. Remove front road wheels. Refer to Section 100-02. 22. Remove crossbeam to engine Hydramount securing bolts. Remove bolt securing crossbeam to Hydramount. Fully withdraw bolt into cro

Page 2454 of 2490

JAGUAR X308 1998 2.G Workshop Manual 27. Support weight of crossbeam. Position a jack under crossbeam. Place a piece of wood between jack and crossbeam. Raise jack to just support crossbeam. 28. From engine compartm

Page 2455 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 31. CAUTION: Slowly lower the crossbeam just sufficient to provide the required clearance. Lowering the crossbeam excessively can damage the suspension and steering pipes. Careful

Page 2456 of 2490

JAGUAR X308 1998 2.G Workshop Manual correctly seated in body locations. 3. Ensure that both engine hydram ounts are correctly seated in crossbeam locations. 4. From engine compartment, install but do not tighten crossbeam
Load next 8 pages
Page:   < prev 1-10 ... 2417-2424 2425-2432 2433-2440 2441-2448 2449-2456 2457-2464 2465-2472 2473-2480 2481-2488 ... 2496 next >
beltopen hoodchange languagelanguageset clockmirror
Popular search:
alarmAUTOMATICaerialjackingtemperature sensoroil capacityRadio code