1999 TOYOTA CAMRY Service Repair Manual

Page 241 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±71
8. ADJUST PRELOAD OF COUNTER DRIVE GEAR
(a) Place SST onto the adjusting nut and hold the shaft in a
vise with soft jaws.
SST 09350±32014 (09351±32080)
(b

Page 242 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±72
12. INSTALL OVERDRIVE ONE±WAY CLUTCH INTO HUB
Be sure that the one±way clutch is installed in the correct
direction.
13. INSTALL RETAINING PLATE
(a) Place

Page 243 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±73
OVERDRIVE CASE DISASSEMBLY
1. REMOVE C0 ACCUMULATOR PISTON FROM OVER-
DRIVE CASE
(a) Using snap ring pliers, remove the snap ring.
(b) Remove the retaining

Page 244 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±74
OVERDRIVE CASE ASSEMBLY
1. INSTALL OIL SEAL RINGS ON OVERDRIVE CASE
Install the oil seal rings to the O/D case groove, then snug
them down by squeezing thei

Page 245 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±75
(b) Install the discs and plates.
Install in order: P=Plate D=Disc
Flange ± D ± P ± P ± D ± P
HINT: There are 2 different thickness plates, as shown in

Page 246 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEVALVE BODY ±
AX±76
VALVE BODY
COMPONENTS
VALVE BODY DISASSEMBLY
1. NOTE THE NUMBERS OF ADJUSTING RINGS
HINT: Count the number of adjusting rings before disas-
sembly of the valve

Page 247 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEVALVE BODY ±
AX±77
3. REMOVE UPPER VALVE BODY COVER
Remove the 9 bolts and upper valve body cover.
4. REMOVE STRAINER GASKETS, PLATE AND SLEEVE
STOPPER FROM UPPER VALVE BODY
(a) R

Page 248 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEVALVE BODY ±
AX±78
7. REMOVE BOLTS FROM LOWER VALVE BODY
Remove the 3 bolts from lower valve body.
8. LIFT OFF LOWER VALVE BODY AND PLATE AS
SINGLE UNIT
Hold the plate to the lowe