1999 TOYOTA CAMRY Service Repair Manual

Page 233 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±63
7. REMOVE PISTON FROM CLUTCH DRUM
(a) Install the clutch drum of the case.
(b) Apply compressed air to the pressure apply hole of the
case.
(c) Remove the p

Page 234 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±64
OVERDRIVE DIRECT CLUTCH ASSEMBLY
1. INSTALL CLUTCH PISTON
(a) Install new O±rings to the piston. Coat the O±rings with
AT F.
(b) Press the piston into the

Page 235 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±65
4. INSTALL SNAP RING
Be sure end gap of the snap ring is not aligned with the
groove of the clutch drum.
5. INSTALL BEARING AND RACE
(a) Coat the bearing wi

Page 236 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±66
COUNTER DRIVE GEAR DISASSEMBLY
1. CHECK OPERATION OF ONE±WAY CLUTCH
(a) While turning the overdrive gear clockwise, install the ov-
erdrive direct clutch i

Page 237 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±67
5. REMOVE NO.3 OVERDRIVE PLANETARY THRUST
WASHER
6. REMOVE ONE±WAY CLUTCH FROM OUTER RACE
Note the direction of the one±way clutch.
7. REMOVE PLUGS FROM P

Page 238 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±68
9. REMOVE INTERMEDIATE SHAFT BEARING
Using SST, press out the bearing from the shaft.
SST 09950±00020
10. REMOVE COUNTER DRIVE GEAR AND FRONT
BEARING
Press

Page 239 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±69
14. REMOVE SNAP RING FROM COUNTER DRIVE GEAR
Using a screwdriver, remove the snap ring.
OVERDRIVE PLANETARY GEAR
INSPECTION
MEASURE PLANETARY PINION GEAR TH

Page 240 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLEOVERDRIVE UNIT ±
AX±70
4. INSTALL REAR BEARING
Using SST, press in the bearing onto the shaft.
SST 09350±32014 (09351±32120)
HINT: Press in the bearing until the side surface of