1999 TOYOTA CAMRY Service Repair Manual

Page 409 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLECOMPONENT PARTS INSTALLATION ±
AX±103
2. PLACE OIL SLINGER AND NEW SPACER
HINT: Install the spacer with the small end downward.
3. INSTALL OUTER RACE TO TRANSAXLE CASE
Using SST,

Page 410 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLECOMPONENT PARTS INSTALLATION ±
AX±104
If the preload is less then specified, retighten the nut
13 N´m (130 kgf´cm, 9 ft´lbf) at a time until the speci-
fied preload is reached

Page 411 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLECOMPONENT PARTS INSTALLATION ±
AX±105
9. INSTALL CARRIER COVER
(a) Remove any packing material and be careful not to drop
oil on the contacting surfaces of the carrier cover and
t

Page 412 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLECOMPONENT PARTS INSTALLATION ±
AX±106
AT3700:Adjusting  shim thickness
mm (in.)
MarkThicknessMarkThickness
02.00 (0.0787)92.45 (0.0965)
12.05 (0.0807)A2.50 (0.0984)
22.10 (0.0827)

Page 413 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLECOMPONENT PARTS INSTALLATION ±
AX±107
12. INSTALL NEW OIL SEAL
(a) Place the oil baffle onto the LH bearing retainer.
(b) Using SST, drive in a new oil seal unit its end is flush

Page 414 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLECOMPONENT PARTS INSTALLATION ±
AX±108
14. INSTALL DRIVE PINION CAP
(a) Install a new O±ring to the cap.
(b) Install the drive pinion cap to the transaxle case.
4±SPEED GEAR UNIT

Page 415 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLECOMPONENT PARTS INSTALLATION ±
AX±109
(f) Using a pin punch, drive in the roll pin until its surface is
flush with the manual valve lever surface.
(g) Match the collar hole to the

Page 416 of 4592

TOYOTA CAMRY 1999  Service Repair Manual AUTOMATIC TRANSAXLECOMPONENT PARTS INSTALLATION ±
AX±110
5. INSTALL FIRST AND REVERSE BRAKE PISTON TO
TRANSMISSION CASE
(a) Coat the new O±rings with ATF.
(b) Install the 2 O±rings on the piston.