Page 481 of 3115

R05181
10 m (33 ft) or more
H04101
BO-148
- BODYSEAT BELT PRETENSIONER
2722 Author: Date:
2004 LAND CRUISER (RM1071U)
(d) Activate the seat belt pretensioner.
(1) Connect the SST red clip to the battery positive (+)
terminal and black clip to the battery negative (-)
terminal.
(2) Check that no one is within 10 m (33 ft) area around
the disc wheel.
(3) Press the SST activation switch and activate the
seat belt pretensioner.
HINT:
The seat belt pretensioner operates simultaneously as the LED
of the SST activation switch lights up.
(e) Dispose of the front seat outer belt (with seat belt preten-
sioner).
CAUTION:
The front seat outer belt is very hot when the seat belt
pretensioner is activated, so leave it alone for at least
30 minutes after activation.
Use gloves and safety glasses when handling a front
seat outer belt with activated seat belt pretensioner.
Always wash your hands with water after completing
the operation.
Do not apply water, etc. to a front seat outer belt with
activated seat belt pretensioner.
(1) Remove the disc wheel and SST.
(2) Place the front seat outer belt in a vinyl bag, tie the
end tightly and dispose of it in the same way as oth-
er general parts disposal.
Page 482 of 3115
BO1LK-02
H07947
H04096
H04097
- BODYSEAT BELT PRETENSIONER
BO-143
2717 Author: Date:
2004 LAND CRUISER (RM1071U)
INSPECTION
1. PRETENSIONER IS NOT ACTIVATED
(a) Perform a diagnostic system check (See page DI-692).
(b) Perform a visual check which includes the following items
with the front seat outer belt removed from the vehicle.
Check for cuts and cracks in, or marked discolor-
ation of the center pillar lower garnish.
Check for cuts and cracks in wire harness, and for
chipping in connectors.
Check for deformation of the center pillar.
CAUTION:
For removal and installation of the front seat outer belt, see
page BO-141 and BO-150.
Be sure to follow the correct procedure.
2. PRETENSIONER IS ACTIVATED
(a) Perform a diagnostic system check (See page DI-692).
(b) Perform a visual check which includes the following items
with the front seat outer belt removed from the vehicle.
Check for deformation of the center pillar.
Check for damage on the connector and wire har-
ness.
Page 483 of 3115

BO21H-03
H04102
A B
H05265
BO-150
- BODYSEAT BELT PRETENSIONER
2724 Author: Date:
2004 LAND CRUISER (RM1071U)
INSTALLATION
NOTICE:
Never use seat belt pretensioner from another ve-
hicle. When replacing parts, replace them with new
parts.
Make sure that the front seat outer belt is installed
with the specified torque.
If the front seat outer belt has been dropped, or there
are cracks, dents or other defects in the case or con-
nector, replace the front seat outer belt with a new
one.
When installing the front seat outer belt, take care that
the wiring does not interfere with other parts and is
not pinched between other parts.
1. INSTALL RETRACTOR OF FRONT SEAT OUTER BELT
(a) Install the retractor of front seat outer belt with the bolt.
Torque:
Upper bolt: 4.9 N´m (50 kgf´cm, 43 in.´lbf)
(b) Connect the pretensioner connector in the order ºAº and
ºBº as shown in the illustration.
2. INSTALL FRONT SEAT OUTER BELT SHOULDER AN-
CHOR
Torque: 43 N´m (440 kgf´cm, 32 ft´lbf)
3. INSTALL FRONT SEAT OUTER BELT FLOOR AN-
CHOR
Torque: 43 N´m (440 kgf´cm, 32 ft´lbf)
4. INSTALL CENTER PILLAR LOWER GARNISH
(a) Install the center pillar lower garnish.
(b) Install the center pillar garnish cover.
5. INSTALL REAR DOOR OPENING TRIM
6. INSTALL REAR DOOR SCUFF PLATE
7. INSTALL FRONT DOOR OPENING TRIM
8. INSTALL FRONT DOOR SCUFF PLATE
Page 484 of 3115

BO21G-03
H05264
Claw
H05265
: 4 Clips
- BODYSEAT BELT PRETENSIONER
BO-141
2715 Author: Date:
2004 LAND CRUISER (RM1071U)
SEAT BELT PRETENSIONER
REMOVAL
NOTICE:
If the wiring connector of the seat belt pretensioner
is disconnected with the ignition switch at ON or ACC,
diagnostic trouble codes will be recorded.
Never use seat belt pretensioner from another ve-
hicle. When replacing seat belt pretensioner, replace
it with a new one.
1. REMOVE FRONT DOOR SCUFF PLATE
2. REMOVE FRONT DOOR OPENING TRIM
3. REMOVE REAR DOOR SCUFF PLATE
4. REMOVE REAR DOOR OPENING TRIM
5. REMOVE CENTER PILLAR LOWER GARNISH
(a) Using a screwdriver, remove the center pillar garnish cov-
er.
HINT:
Tape the screwdriver tip before use.
(b) Using a screwdriver, remove the center pillar lower gar-
nish as shown in the illustration.
HINT:
Tape the screwdriver tip before use.
6. REMOVE FRONT SEAT OUTER BELT SHOULDER AN-
CHOR
7. REMOVE FRONT SEAT OUTER BELT FLOOR AN-
CHOR
8. REMOVE RETRACTOR OF FRONT SEAT OUTER
BELT
CAUTION:
Never disassemble the retractor of front seat outer belt.
NOTICE:
When removing the retractor of front seat outer belt, take
care not to pull the seat belt pretensioner wire harness.
Page 485 of 3115
H04094
A
B BO-142
- BODYSEAT BELT PRETENSIONER
2716 Author: Date:
2004 LAND CRUISER (RM1071U)
(a) Disconnect the pretensioner connector in the order ºAº
and ºBº as shown in the illustration.
CAUTION:
When removing the seat belt pretensioner, work must be
started 90 seconds after the ignition switch is turned to the
ºLOCKº position and the negative (-) terminal cable is dis-
connected from the battery.
(b) Remove the bolt and retractor of front seat outer belt.
Page 486 of 3115
BO1LM-02
- BODYSEAT BELT PRETENSIONER
BO-149
2723 Author: Date:
2004 LAND CRUISER (RM1071U)
REPLACEMENT
REPLACE REQUIREMENTS
In the following cases, replace the seat belt pretensioner.
If the seat belt pretensioner has been activated.
If the seat belt pretensioner has been found to be faulty in troubleshooting.
If the front seat outer belt has been found to be faulty during the check of items 1-(b) or 2-(b).
If the front seat outer belt has been dropped.
CAUTION:
For removal and installation of the seat belt pretensioner, see page BO-141 and BO-150.
Be sure to follow the correct procedure.
Page 487 of 3115
BO1KY-04
H18930
Center Pillar Garnish Adjustable Anchor
Front Door
Opening Trim
Center Pillar
Lower Garnish
Front Door Scuff PlateRear Door
Scuff Plate
Front Seat
Front Seat
Inner BeltRear Door
Opening Trim
: Specified torque
N´m (kgf´cm, ft´lbf)Front Seat Outer Belt
42 (430, 31)
5.0 (51, 44 in.´lbf)
42 (430, 31)
42 (430, 31)
42 (430, 31)
Front Seat Belt:
42 (430, 31)
42 (430, 31)
- BODYSEAT BELT
BO-137
2711 Author: Date:
2004 LAND CRUISER (RM1071U)
SEAT BELT
COMPONENTS
Page 488 of 3115
H18931
Upper Roof Side
Inner Garnish
Quarter Trim Panel
Assist Grip
Roof Headlining
Rear Trim Rear Door Scuff Plate
Rear Mat Set Plate
Rear No. 2 Lap
Type Center with
Inner Belt
Rear No. 2 Seat
Inner Belt
Rear No. 1 Seat
Inner BeltRear No. 2 Seat
Outer Belt
Rear Seat Shoulder
Belt Cover Rear Seat Shoulder
Belt Guide
Rear No. 1 Seat Outer
Center BeltRear No. 1 Seat
Outer Belt
: Specified torqueN´m (kgf´cm, ft´lbf)Rear No. 1 Seat
Inner Belt
Adjustable Anchor
42 (430, 31)
42 (430, 31)
Rear Seat Belt:
42 (430, 31)
42 (430, 31)
42 (430, 31)
42 (430, 31)
42 (430, 31)
42 (430, 31)
42 (430, 31)
42 (430, 31)
42 (430, 31)
27 (275, 20)
CRS Tether Anchor
BracketCRS Tether Anchor
Bracket Cover
42 (430, 31)3.9 (40, 35 in.´lbf)
Assist Grip Plug
42 (430, 31)
BO-138
- BODYSEAT BELT
2712 Author: Date:
2004 LAND CRUISER (RM1071U)