1998 TOYOTA LAND CRUISER Factory Repair Manual

oil transmission fluid set clock oil filter tire pressure reset fuel

Load previous 8 pages

Page 929 of 3115

TOYOTA LAND CRUISER 1998 Factory Repair Manual D12645
NSSD
AT 4 NSSL
AT L
DI-408
- DIAGNOSTICSAUTOMATIC TRANSMISSION
601 Author: Date:
2004 LAND CRUISER (RM1071U)
2 Check transmission control switch.
PREPARATION:
(a) Connect the park/neutral

Page 930 of 3115

TOYOTA LAND CRUISER 1998 Factory Repair Manual D11591
ON
E1(-)P(+)
R(+)
3(+)N(+) L(+)
4(+)D(+)
2(+)
NSW(+)
E5E6E7E8E9
- DIAGNOSTICSAUTOMATIC TRANSMISSION
DI-409
602 Author: Date:
2004 LAND CRUISER (RM1071U)
3 Measure voltage between each termi

Page 931 of 3115

TOYOTA LAND CRUISER 1998 Factory Repair Manual DI-410
- DIAGNOSTICSAUTOMATIC TRANSMISSION
603 Author: Date:
2004 LAND CRUISER (RM1071U)
DTC P0710 Transmission Fluid Temperature Sensor ºAº
Circuit
DTC P0712 Transmission Fluid Temperature Sens

Page 932 of 3115

TOYOTA LAND CRUISER 1998 Factory Repair Manual - DIAGNOSTICSAUTOMATIC TRANSMISSION
DI-41 1
604 Author: Date:
2004 LAND CRUISER (RM1071U)
MONITOR STRATEGY
P0710ATF temperature sensor/Range check (Fluttering)
Related DTCsP0712ATF temperature sen

Page 933 of 3115

TOYOTA LAND CRUISER 1998 Factory Repair Manual D12759
Electronically Controlled
Transmission Solenoid
THO1
Y
1 2
E2ECM
4
28 E1
G-Y
11
10
9THO2
E5 E6E6
L
BR-W Y OO
G-Y
L
BR-W
If1 EB2EB2
OT+
OT2+ OT-
OT2-
EB3 BR-W BR-W BR-W
32432 DI-412
- DIAGNOSTI

Page 934 of 3115

TOYOTA LAND CRUISER 1998 Factory Repair Manual 1
152 3 4 5 6 7 8
9 10 11 12
13 14
D11994OT+OT-
- DIAGNOSTICSAUTOMATIC TRANSMISSION
DI-413
606 Author: Date:
2004 LAND CRUISER (RM1071U)
INSPECTION PROCEDURE
HINT:
According to the DATA LIST displ

Page 935 of 3115

TOYOTA LAND CRUISER 1998 Factory Repair Manual D12792
THO1
E2
E5E6E7E8E9
DI-414
- DIAGNOSTICSAUTOMATIC TRANSMISSION
607 Author: Date:
2004 LAND CRUISER (RM1071U)
2 Measure resistance between terminal THO1 and E2 of ECM connector.
PREPARATION:

Page 936 of 3115

TOYOTA LAND CRUISER 1998 Factory Repair Manual - DIAGNOSTICSAUTOMATIC TRANSMISSION
DI-415
608 Author: Date:
2004 LAND CRUISER (RM1071U)
DTC P0711 Transmission Fluid Temperature Sensor ºAº
Performance
CIRCUIT DESCRIPTION
The ATF temperature s

- DIAGNOSTICSAUTOMATIC TRANSMISSION
DI-415
608 Author: Date:
2004 LAND CRUISER (RM1071U)
DTC P0711 Transmission Fluid Temperature Sensor ºAº
Performance
CIRCUIT DESCRIPTION
The ATF temperature sensor converts fluid temperature into a resistance value which is input into the ECM.
DTC No.DTC Detecting ConditionTrouble Area
P0711
(A) Both (a) and (b) are detected: (2-trip detection logic)
(a) Intake air and engine coolant temps. are more than -10°C
(14°F) at engine start
(b) After normal driving for over 20 min. and 9 km (6 mile) or
more, ATF temp. is less than 20°C (68°F)
(B) After 17 min. of engine start, the ATF temp. is 110°C
(230°F) or more (2-trip detection logic).
Open or short in ATF temperature sensor No. 1 circuit
ATF temperature sensor No. 1
ECM
MONITOR DESCRIPTION
The ATF temperature sensor converts the ATF temperature to an electrical resistance value. Based on the
resistance, the ECM determines the ATF temperature and detects an opens or shorts in the ATF temperature
circuit or a fault of the ATF temperature sensor.
After running the vehicle for a certain period, the ATF temperature should increase. If the ATF temperature
is below 10C (50F) after running the vehicle for a certain period, the ECM interprets this as a fault, and
turns on the MIL.
When the ATF temperature is 110C (230F) or more after 17 minutes of engine cold start, the ECM also
determines this as a fault, turns on the MIL, and stores the DTC.
MONITOR STRATEGY
Related DTCsP0711ATF temperature sensor/Rationality check
Required sensors/ComponentsATF temperature sensor
Frequency of operationContinuous
Duration3 sec.
MIL operation2 driving cycles
Sequence of operationNone
TYPICAL ENABLING CONDITIONS
ItSpecificationItemMinimumMaximum
The monitor will run whenever the follow-
ing DTCs are not present.See page DI-361
ATF Temperature sensor ºAº circuit
ECT (Engine coolant temperature) sensor
circuitThere is no malfunction in the circuit shown on the left.
IAT (Intake air temperature) sensor circuit
Time after engine start18 min. and 20 sec. or more-
ECT-15°C (5°F) or more-
Driving distance after engine start9 km (6 mile) or more-
IAT (12 sec. after engine start)-20°C (-4°F) or more-
ECT (12 sec. after engine start)-20°C (-4°F) or more-
DIC30-01

Load next 8 pages

Page: < prev 1-10 ... 897-904 905-912 913-920 921-928 929-936 937-944 945-952 953-960 961-968 ... 3120 next >

low beam buttons automatic transmission fluid adblue keyless USB port