1986 TOYOTA CAMRY V20 Service Information

Page 129 of 2389

TOYOTA CAMRY V20 1986  Service Information AT7755
AT4320
AT4314
AT4671 AT4602
(c) Using a screwdriver, install the snap ring.
4. CHECK OPERATION OF CLUTCH PISTONS
(a) Plug one hole with your hand.
(b) Apply compressed air into the other hole a

Page 130 of 2389

TOYOTA CAMRY V20 1986  Service Information AT4335
Mark Thickness mm (in.) Mark Thickness mm (in.)
A
B
C
D1.00 (0.0394)
1.05 (0.0413)
1.10 (0.0433)
1.15 (0.0453)E
F
G1.20 (0.0472)
1.25 (0.0492)
1.30 (0.0512)
AT4338
Matchmark
AT4336AT4603
(Front

Page 131 of 2389

TOYOTA CAMRY V20 1986  Service Information AT4429
AT4317
AT7756
Oil 
Bath 212°F (100°C)
AT4297
Matchmark
AT4337Matchmark
8. INSTALL FRONT DIFFERENTIAL CASE
(a)  Install the front differential case to the ring gear
mounting right case.
HINT:

Page 132 of 2389

TOYOTA CAMRY V20 1986  Service Information AT7758
AT4301
Oil Seal Ring
AT4302
Sleeve
AT4299
Outer Race
AT7757
10. CHECK OPERATION OF FRONT DIFFERENTIAL
Check that the front differential turns smoothly.
11. INSTALL SPEEDOMETER DRIVE GEAR
(a) Pl

Page 133 of 2389

TOYOTA CAMRY V20 1986  Service Information AT3683
SST A540E
AT3684
SST
TA0041
SST
TA0042
SST
TA0043
SST
DISASSEMBLY OF DRIVE PINION
1. REMOVE DRIVE PINION SHAFT BEARING
Using SST and a press, remove the bearing.
SST 09950-00020
2. (A540E)
REMO

Page 134 of 2389

TOYOTA CAMRY V20 1986  Service Information AT3686 AT3803
A540E
AT3687
SST A540E
AT3688
SST
AT3689
SST
AT3685
SST A540E
2. (A540E)
INSTALL OIL SEALS TO CAGE
(a) Using SST, press in a new oil seal with the lip facing
downward.
SST 09325-12010
Oi

Page 135 of 2389

TOYOTA CAMRY V20 1986  Service Information AT4672r Non-reusable part kg-cm(ft-lb, N-m)
: Specified torque
260 (19, 25)
Dynamic Damper
260 (19, 25)
r Oil Seal Transfer Left Case
400 (29, 39)700 (51, 69)
r GasketTransfer Extension
Housing r Appl

Page 136 of 2389

TOYOTA CAMRY V20 1986  Service Information INSTALLATION OF COMPONENT PARTS
Disassembly, inspection and assembly of each component group have been indicated in the pre-
ceding chapter. Before assembly, make sure, again, that all component group