1986 TOYOTA CAMRY V20 Service Information

towing capacitykeylessfuse diagramair filterseat memory timing belt
Popular search:
remote controlbrakedimensionsturn signal bulbfour wheel drivecheck engine lightclock
Previous
Next
Load previous 8 pages

Page 409 of 2389

TOYOTA CAMRY V20 1986 Service Information 6. ADJUST SIDE BEARING PRELOAD Using SST and a torque meter, measure the preload of the ring gear. SST 09564±32011 Preload (at starting): New bearing 10 ± 16 kg±cm (8.7 ± 13.9 in.±Ib, 1.0 ± 1.6

Page 410 of 2389

TOYOTA CAMRY V20 1986 Service Information 7. REMOVE DIFFERENTIAL CASE AND COMPONENT PARTS If the preload is adjusted within specification, remove the bearing retainer, differential case, RH side bearing and shim. Be careful not to lose the ad

Page 411 of 2389

TOYOTA CAMRY V20 1986 Service Information Torque Converter INSPECTION OF TORQUE CONVERTER 1. INSERT SST IN END OF TORQUE CONVERTER (a) Insert a turning tool into the inner race of the one±way clutch. SST 09350±32014 f09351±320101 2. TEST O

Page 412 of 2389

TOYOTA CAMRY V20 1986 Service Information INSTALLATION OF COMPONENT PARTS Disassembly, inspection and assembly of each component group have been indicated in the preceding chapter. Before assembly, make sure, again, that all component groups

Page 413 of 2389

TOYOTA CAMRY V20 1986 Service Information 8. Be sure to install the thrust bearings and races in the correct direction and position. Rear Bearing Race Front Bearing Race Inner Diameter Inner Diameter Inner DiameterOuter Diameter Outer Diamete

Page 414 of 2389

TOYOTA CAMRY V20 1986 Service Information 2. INSTALL DRIVE PINION SHAFT INTO CASE Slightly tap the cage into the case until the groove with the bore can be seen. HINT: Drive in the bearing cage until the surface of the bearing cage passes thr

Page 415 of 2389

TOYOTA CAMRY V20 1986 Service Information (b) Using SST, driven in gear onto the shaft until the nut can be installed on the threads of the shaft. NOTICE: Be careful not to cause an impact to the transmission case. SST 09350±32014 (09351±32

Page 416 of 2389

TOYOTA CAMRY V20 1986 Service Information (e) Turn the gear counterclockwise and clockwise several times. (d) Using a torque meter, measure the preload of the drive pinion. Preload (at starting) : New bearing 10 ± 16 kg±cm (8.7 ± 13.9 in.
Load next 8 pages
Page:   < prev 1-10 ... 377-384 385-392 393-400 401-408 409-416 417-424 425-432 433-440 441-448 ... 2392 next >
homelinkfuseheadlight bulboilreset infotainment systemspare wheel
Popular search:
hood releasecheck transmission fluidparking sensorsresetservice schedulediagramopen gas tank