1986 TOYOTA CAMRY V20 Service Information

oil typechange timehood openwinter tiresnavigation updatecarplay
Popular search:
radio antennacatalytic converteroil capacitywindowoil filterconditioncheck engine light
Previous
Next
Load previous 8 pages

Page 561 of 2389

TOYOTA CAMRY V20 1986 Service Information 5. INSTALL OVERDRIVE PLANETARY GEAR ONTO OVERDRIVE DIRECT CLUTCH While turning the overdrive planetary gear clockwise install it onto the overdrive direct clutch. 2. INSTALL FLANGE, DISCS AND PLATES (

Page 562 of 2389

TOYOTA CAMRY V20 1986 Service Information HINT: If the overdrive planetary gear is properly installed onto the direct clutch, the counter drive gear height from the overdrive case will be about 24mm (0.94 in.). ± AUTOMATIC TRANSAXLEComponent

Page 563 of 2389

TOYOTA CAMRY V20 1986 Service Information Differential Assembly (A540E) ± AUTOMATIC TRANSAXLEComponent Parts (Differential Assembly A540E).AT±322

Page 564 of 2389

TOYOTA CAMRY V20 1986 Service Information DISASSEMBLY OF DIFFERENTIAL CASE 1. REMOVE SIDE BEARING Using SST, remove the two side bearings. SST 09950±20017 2. REMOVE RING GEAR (a) Place the matchmarks on both the differential case and ring ge

Page 565 of 2389

TOYOTA CAMRY V20 1986 Service Information (c) Using a plastic hammer, tap out the differential left case. (d) Remove the speedometer drive gear from the differential right case. 4. DISASSEMBLE LH BEARING RETAINER (a) Using a hammer and screwd

Page 566 of 2389

TOYOTA CAMRY V20 1986 Service Information ASSEMBLY OF DIFFERENTIAL CASE 1. INSTALL RH OIL SEAL TO RH RETAINER (a) Using SST, drive in a new oil seal until its surface is flush with the surface of RH retainer. SST 09316±60010 (09316±00010) (

Page 567 of 2389

TOYOTA CAMRY V20 1986 Service Information (d) Using a dial indicator, measure the backlash of one pinion gear while holding the side gear. Standard backlash: 0.05 ± 0.20 mm (0.0020 ± 0.0079 in.) (e) Install the side gear and spider with fou

Page 568 of 2389

TOYOTA CAMRY V20 1986 Service Information 4. INSTALL RING GEAR (a) Clean the contact surface of the differential case. (b) Heat the ring gear to about 212 °F (100°C) in an oil bath. NOTICE: Do not heat the ring gear above 230°F (110°C). (
Load next 8 pages
Page:   < prev 1-10 ... 529-536 537-544 545-552 553-560 561-568 569-576 577-584 585-592 593-600 ... 2392 next >
roof rackspare tirewheel bolt torqueinfotainmentESPparking sensors
Popular search:
fog lightbrake pads replacementservice intervalfuel pumplow beammaintenanceclock