1986 TOYOTA CAMRY V20 Service Information

lengthtorquefuel filter locationsuspensionoil typeseat memory
Popular search:
wiper fluidlightspare wheelpower steering fluidoil changecheck transmission fluidaudio
Previous
Next
Load previous 8 pages

Page 601 of 2389

TOYOTA CAMRY V20 1986 Service Information 9. REMOVE FRONT DIFFERENTIAL LEFT CASE (a) Using a torx wrench, remove the sixteen screws from the left case. (b) Separate the left case and right case.. NOTICE: Do not scratch the contact surface of

Page 602 of 2389

TOYOTA CAMRY V20 1986 Service Information REPLACEMENT OF RING GEAR MOUNTING CASE BEARINGS 1. REMOVE RING GEAR MOUNTING LEFT CASE BEARING Using SST, remove the bearing. SST 09950±00020, 09950±00030(g) Using a small screwdriver, remove the re

Page 603 of 2389

TOYOTA CAMRY V20 1986 Service Information 5. REMOVE RING GEAR MOUNTING LEFT CASE BEARING OUTER RACE FROM LH BEARING RETAINER (a) Using a hammer and screwdriver, remove the oil seal. (b) Remove the oil baffle from the LH bearing retainer. 3. R

Page 604 of 2389

TOYOTA CAMRY V20 1986 Service Information INSPECTION OF HYDRAULIC MULTIPLATE CLUTCH INSPECT DISCS, PLATES AND FLANGE Check if the sliding surfaces of discs, plates and flange are worn or burnt. If necessary, replace them. HINT: wIf the lining

Page 605 of 2389

TOYOTA CAMRY V20 1986 Service Information 2. INSTALL PISTON RETURN SPRING (a) Place the spring on the piston. (b) Place SST on the spring retainer, and compress the spring with a press. SST 09350±32014 (09351±32070) (c) Using snap ring plie

Page 606 of 2389

TOYOTA CAMRY V20 1986 Service Information 6. CHECK AND ADJUST FRONT DIFFERENTIAL SIDE GEAR BACKLASH (Front Differential Left Case) (a) Install the following parts: w Side gear thrust washer wSide gear wFour differential pinion gears wFour pin

Page 607 of 2389

TOYOTA CAMRY V20 1986 Service Information (b) Using a dial indicator, measure the backlash of one pinion gear while holding the side gear toward the case. Backlash: 0.05 ± 0.20 mm (0.0020 ± 0.0079 in.) Referring to the table below, select t

Page 608 of 2389

TOYOTA CAMRY V20 1986 Service Information 9. INSTALL RING GEAR (a) Clean the contact surface of the ring gear mounting left case. (b) Heat the ring gear to about 212* F (1000C) in an oil bath. NOTICE: Do not heat the ring gear above 230°F (1
Load next 8 pages
Page:   < prev 1-10 ... 569-576 577-584 585-592 593-600 601-608 609-616 617-624 625-632 633-640 ... 2392 next >
remote controlspare wheeloil temperaturerefuellingrefrigerant typerun flat
Popular search:
wheel sizejump cablefuseshood releaserecommended oilrear view mirrorfuel consumption