1986 TOYOTA CAMRY V20 Service Information

engine oil capacityoverheatingcoolingoctanedead batterywiring
Popular search:
air conditioning relaychild restraintwiper fluidemergency towingautomatic transmissioncheck enginelow oil pressure
Previous
Next
Load previous 8 pages

Page 873 of 2389

TOYOTA CAMRY V20 1986 Service Information 3. REMOVE PISTON FROM CYLINDER (a) Put a piece of cloth or an equivalent between the pis- ton and cylinder. (b) Use compressed air to remove the piston from the cyl- inder. CAUTION: Do not place you

Page 874 of 2389

TOYOTA CAMRY V20 1986 Service Information 3. MEASURE ROTOR DISC RUNOUT HINT: Before measuring the runout, confirm that the front hub bearing play is within specification. Measure the rotor disc runout at 10 mm (0.39 in.) from the outer edge

Page 875 of 2389

TOYOTA CAMRY V20 1986 Service Information ASSEMBLY OF CYLINDER (See page BR±18) 1. APPLY LITHIUM SOAP BASE GLYCOL GREASE TO PARTS INDICATED WITH ARROWS 4. INSTALL DUST BOOTS AND SLIDING BUSHING (a) Install the dust boots into the brake cy

Page 876 of 2389

TOYOTA CAMRY V20 1986 Service Information INSTALLATION OF CYLINDER (See page BR±18) 1. INSTALL PADS (See Steps 7 and 8 on page BR±20) 2. INSTALL CYLINDER (See step 9 on page BR±20) 3. INSTALL FLEXIBLE HOSE TO BRAKE CYLINDER Set the flexib

Page 877 of 2389

TOYOTA CAMRY V20 1986 Service Information REMOVAL OF REAR BRAKE 1. INSPECT SHOE LINING THICKNESS Remove the inspection hole plug, and check the shoe lin- ing the thickness through the hole. If less than minimum, replace the shoes. Minimum th

Page 878 of 2389

TOYOTA CAMRY V20 1986 Service Information 5. REMOVE REAR SHOE (a) Using SST, remove the shoe hold±down spring, cups and pin. SST 09718±00010 (b) Using a screwdriver, disconnect the parking brake. cable from the anchor plate. (c) Using p

Page 879 of 2389

TOYOTA CAMRY V20 1986 Service Information 2. MEASURE BRAKE SHOE LINING THICKNESS Standard thickness: 5.0 mm (0.197 in. ) Minimum thickness: 1 .0 mm (0.039 in.) If the shoe lining is less than minimum or shows signs of uneven wear, replace th

Page 880 of 2389

TOYOTA CAMRY V20 1986 Service Information 5. MEASURE CLEARANCE BETWEEN BRAKE SHOE AND LEVER Using a feeler gauge, measure the clearance. Standard clearance: Less than 0.35 mm (0.0138 in.) If the clearance is not within specification, replace
Load next 8 pages
Page:   < prev 1-10 ... 841-848 849-856 857-864 865-872 873-880 881-888 889-896 897-904 905-912 ... 2392 next >
spare wheelrimsadblue resetdashboard warning lightsmanual transmissionclutch
Popular search:
wheel alignmentwindowhigh beamengine coolantair conditioning relayrelaylight