1986 TOYOTA CAMRY V20 Service Information

ignitiondiagramradiowinter tyresdimensionsengine oil capacity
Popular search:
clock resetwiringwheel boltswasher fluidalternator beltengine oillight
Previous
Next
Load previous 8 pages

Page 233 of 2389

TOYOTA CAMRY V20 1986 Service Information INSTALLATION OF COMPRESSOR (See page AC±25) 1. INSTALL COMPRESSOR WITH FOUR MOUNTING BOLTS Torque: 3S±FE engine 280 kg±cm (20 ft±lb, 27 N±m) 2VZ±FE engine 250 kg±cm (18 ft±lb, 25 N

Page 234 of 2389

TOYOTA CAMRY V20 1986 Service Information RECEIVER (See page AC±12) ON±VEHICLE INSPECTION CHECK SIGHT GLASS, FUSIBLE PLUG AND FITTINGS FOR LEAKAGE Use a gas leak tester. Repair as necessary. REMOVAL OF RECEIVER 1. DISCHARGE REFRIGERATION SY

Page 235 of 2389

TOYOTA CAMRY V20 1986 Service Information CONDENSER (See page AC±12) ON±VEHICLE INSPECTION 1. CHECK CONDENSER FINES FOR BLOCKAGE OR DAMAGE If the fins are clogged, wash them with water and dry with compressed air. NOTICE: Be careful not t

Page 236 of 2389

TOYOTA CAMRY V20 1986 Service Information CONDENSER FAN MOTOR INSPECTION ON FAN MOTORS 1. CHECK OPERATION OF FAN MOTOR HINT: The fan motor operates at two speeds depending on the water temperature and the A/C switch. 3S±FE Engine Model 90°

Page 237 of 2389

TOYOTA CAMRY V20 1986 Service Information 96°C (205°F) or above or the refrigerant pressure is approx. 15.5 kg/cm2 (220psi, 1,520 kPa) or greater91 °C (196°F) ± 96°C (205°F) (2VZ±FE Engine Model) 91 °C (196°F) or below 96°C (205°

Page 238 of 2389

TOYOTA CAMRY V20 1986 Service Information 2. INSPECT FAN MOTOR (a) Disconnect 2±P connector of the fan motor. (b) Using wire harness, apply battery voltage to the con- nector. (c) Confirm smooth rotation of the motor within the spe- cifie

Page 239 of 2389

TOYOTA CAMRY V20 1986 Service Information 2. INSPECT FAN MOTOR (a) Disconnect 2±P connector of the fan motor. (b) Using wire harness, apply battery voltage to the con- nector. (c) Confirm smooth rotation of the motor within the spe- cifie

Page 240 of 2389

TOYOTA CAMRY V20 1986 Service Information RELAYS INSPECTION OF A/C RELAY 1. REMOVE COVER OF RELAY BOX 2. REMOVE RELAY 3. INSPECT RELAY CONTINUITY (Magnetic Clutch Relay) If continuity is not as specified, replace the relay. (A/C Fan Relay No
Load next 8 pages
Page:   < prev 1-10 ... 201-208 209-216 217-224 225-232 233-240 241-248 249-256 257-264 265-272 ... 2392 next >
resetservice interval resetlumbar supportclimate controlautomatic transmissionspark plugs replace
Popular search:
wheel boltstiming beltfuel capcoolant reservoirclock settingignitioncoolant temperature