Page 169 of 2000

IN–24INTRODUCTION – REPAIR INSTRUCTION
IN
4. NOTICE FOR USING SWING ARM TYPE LIFT
(a) Follow safety procedures outlined in its instruction
manual.
(b) Use a swing arm equipped with a rubber
attachment, as shown in the illustration.
(c) When using the lift, make sure that the vehicle is
stabilized so that it will not tilt while work is being
performed. Stabilize the vehicle by adjusting the lift
arm's length and vehicle's position.
(d) When using the lift, its center should be as close to
the vehicle's center of gravity as possible (length of
"L" in the illustration should be as short as possible).
(e) Set the vehicle on the lift as level as possible. Then
match the groove of the cradle to the rigid rack
support location.
(f) Be sure to lock the swing arms before lifting and
during work (if equipped with arm locks).
(g) Lift the vehicle up off the ground. Stand at a safe
distance and shake the vehicle to check its stability.
5. NOTICE FOR USING PLATE TYPE LIFT
(a) Follow safety procedures outlined in its instruction
manual.
(b) Use plate lift attachments (rubber lifting blocks) on
top of the plate surface.
D100925E01
Page 170 of 2000
INTRODUCTION – REPAIR INSTRUCTIONIN–25
IN
(c) Refer to the illustration below to determine how to
properly set the vehicle.
HINT:
(d) Use the lift to raise the vehicle up off the ground,
and shake it to make sure that it is stable.
D100924E01
Right and left set position Place the vehicle over the center of the lift.
Front and rear set position Place the attachments at the ends of the rubber plate surface, under
the vehicle lift pad (A and C in the illustration). Raise the plate slightly
and reposition the vehicle so the top of the attachment (B in the
illustration) is aligned with the front side notch in the vehicle rocker
flange.
Page 171 of 2000
PREPARATION – 2AZ-FE ENGINE CONTROL SYSTEMPP–3
PP
EQUIPMENT
Ohmmeter -
Service wire -
Torque wrench -
Page 172 of 2000
PP–22PREPARATION – 2AZ-FE COOLING
PP
EQUIPMENT
Ohmmeter -
Radiator cap tester -
Thermometer -
To r q u e w r e n c h -
Slide calipers -
Heater -
Page 173 of 2000
PREPARATION – 2AZ-FE COOLINGPP–23
PP
COOLANT
Capacity Classification
6.8 liters (7.2 US qts, 5.9 Imp. qts) Use only "TOYOTA Super Long Life Coolant" or similar high quality
ethylene glycol based non-silicate, non-amine, non-nitrite, non-borate
coolant with long-life hybrid organic acid technology (coolant with
long-life hybrid organic acid technology consists of a combination of
low phosphates and organic acids).
Page 174 of 2000
PREPARATION – 2AZ-FE CHARGINGPP–31
PP
RECOMMENDED TOOLS
09082-00040 TOYOTA Electrical Tester -
(09083-00150) Test Lead Set -
Page 175 of 2000
PP–32PREPARATION – 2AZ-FE CHARGING
PP
EQUIPMENT
Ammeter -
Ohmmeter -
Service wire -
To r q u e w r e n c h -
Page 176 of 2000
PP–76PREPARATION – BRAKE CONTROL
PP
EQUIPMENT
Soft jaw vise Skid control sensor
To r q u e w r e n c h -