2006 TOYOTA RAV4 Service Repair Manual

handbrakeclimate controlrear view mirrorimmobilizeroverheatingservice
Popular search:
windshield wiperschild restraintbrake fluidcoolant reservoirbuttonsheightseats
Previous
Next
Load previous 8 pages

Page 833 of 2000

TOYOTA RAV4 2006 Service Repair Manual 2GR-FE EMISSION CONTROL – EMISSION CONTROL SYSTEMEC–9 EC (c) Apply 4 kPa (41 kgf/cm2, 30 mmHg) of pressure to the vent line of the fuel tank. HINT: Perform this inspection with the fuel tank le

Page 834 of 2000

TOYOTA RAV4 2006 Service Repair Manual EC–122GR-FE EMISSION CONTROL – CANISTER EC INSPECTION 1. INSPECT CANISTER (a) Visually check the canister for cracks or damage. If cracks or damage is found, replace the canister. (b) Check the

Page 835 of 2000

TOYOTA RAV4 2006 Service Repair Manual 2GR-FE EMISSION CONTROL – CANISTEREC–13 EC (d) Check the diaphragm. (1) Remove the air hose between ports A and B. (2) While holding the vent, purge and air inlet ports closed, apply vacuum 1.4

Page 836 of 2000

TOYOTA RAV4 2006 Service Repair Manual EC–142GR-FE EMISSION CONTROL – CANISTER EC (c) Install the vent line tube. (1) Connect the pipe to the fuel tube connector, as shown in A in the illustration. Then push up the retainer to lock

Page 837 of 2000

TOYOTA RAV4 2006 Service Repair Manual EC–202GR-FE EMISSION CONTROL – VENTILATION VALVE EC INSTALLATION 1. INSTALL VENTILATION VALVE SUB-ASSEMBLY (a) Apply adhesive to 2 or 3 threads of the ventilation valve. Adhesive: Toyota genuin

Page 838 of 2000

TOYOTA RAV4 2006 Service Repair Manual EC–242GR-FE EMISSION CONTROL – AIR FUEL RATIO SENSOR EC INSTALLATION 1. INSTALL AIR FUEL RATIO SENSOR (for Sensor 1) (a) Using SST, install the sensor to the exhaust manifold. SST 09224-00010 T

Page 839 of 2000

TOYOTA RAV4 2006 Service Repair Manual EC–262GR-FE EMISSION CONTROL – HEATED OXYGEN SENSOR EC REMOVAL 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negat

Page 840 of 2000

TOYOTA RAV4 2006 Service Repair Manual 2GR-FE EMISSION CONTROL – HEATED OXYGEN SENSOREC–27 EC INSTALLATION 1. INSTALL HEATED OXYGEN SENSOR (for Sensor 2) (a) Using SST, install the sensor to the exhaust pipe. SST 09224-00010 Torque:
Load next 8 pages
Page:   < prev 1-10 ... 801-808 809-816 817-824 825-832 833-840 841-848 849-856 857-864 865-872 ... 2000 next >
seat memory horntire pressure resetopen hoodparking sensorsfour wheel drive
Popular search:
oil dipsticktire sizetraction controlseatsbrake rotordisplayInstall oil pan sub-assembly