Page 1417 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Transaxle
adjustable
.
(11) Put a dab of petrolatum on the top of low/reve rse,
accumulator piston. Using a
bar or,
equivalent, press the bar evenly against the
so it sticks to the piston. Pull piston’.
two return springs.
input shaft end play before disassembly Will
usually indicate when a No. 4 thrust plate
is
required (except when major parts are
No. 4 thrust plate is the overdrive
hub.
Attach a dial indicator to transaxle its
plunger seated against end of input shaft.
Move input shaft in and out to obtain end
reading.
End play specifications are
to 0.64 mm to
inch.). Record indicator reading for reference
reassembling the. transaxle.
input speed sensor.
TSB Revision
Page 1418 of 2103
the weights of the pullers against the
of the tools to loosen the pump. on input
while loosening pump. ,
o i l p u m p .
.
oil pump gasket.
,
,,
TSB Revision
Page 1419 of 2103
needle bearing
washer
cooler
No. 1 caged needle
input clutches assembly.
No. 4 thrust plate and front sun gear
and pull to carrier and rear
assembly.
Remove No. 6 needle bearing.
Page 1420 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Transaxle
rear sun gear and No. 7 needle bearing.
spring compressor Using the special
tool, compress the
clutch retainer just enough to
remove the snap ring.
Using a screwdriver, remove the clutch retainer snap
ring.
up clutch retainer by hand.
clutch retainer.
clutch spring.
TSB Revision
Page 1421 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Transaxle
Clutchplate
TSB Revision
Low/reverse
One disc from
clutch pack.
NOTE
Tag clutch pack for reassembly identification.
,
tapered ring by prying with a
as shown.
low/reverse reaction plate.
one disc from low/reverse clutch.
a screwdriver, out the low/reverse reaction
flat snap ring.
Caution
Use care not to scratch the plate with
screwdriver tip while prying out snap ring.
Page 1422 of 2103
low/reverse clutch pack. ,
NOTE
Tag low/reverse clutch pack for identification.
A U T O M A T I C T R A N S A X L E
rear bolts.
rear cover.
holding transfer shaft gear with Holder
loosen transfer shaft nut.
transfer shaft gearnut and lock washer.
Page 1423 of 2103
Transfer shaft
Bearing cup retainer
Gear Puller and to
transfer shaft gear.
Using the appropriate wrench, turn, “the, center
clockwise to remove gear.
transfer shaft gear and shim.
(42) Remove bearing cap retainer.
Bearing Puller and Button
on transfer shaft gear bearing to remove bearing.
Bearing Cup Remover- 1, remove transfer
shaft gear bearing cup.
Page 1424 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Transaxle
Transfer shaft
transfer shaft ‘bearing snap
Pliers
transfer shaft with
oil baffle and bearing cup from
transfer shaft Bearing
holding output gear with
output gear bolt.
TSB Revision