1990 MITSUBISHI SPYDER Service Repair Manual

tiresbrake pads replacementfuel capjump start terminalsrooftire pressure
Popular search:
fuel pumpheadlight aimingradio antennawarning lightjump startwiper fluidspark plugs replace
Previous
Next
Load previous 8 pages

Page 225 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE OVERHAUL Belt TDCInstall belt in ‘this here belt. Starting at the crankshaft, go around the water pump sprocket, ‘idler pulley, and then around the tensioner pulle

Page 226 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE OVERHAUL Belt engine mount Tighten bolts to 41 Nm (30 crankshaft damper using Using Special Tools and to hold damper, tighten crankshaft bolt to 62 Nm (45 Rev

Page 227 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE OVERHAUL Cooling System COOLING SYSTEM COMPONENTS REMOVAL (1) Remove water pump attaching screws to engine. Thermostat Thermostat Gasket (2) Remove level gauge. (3) Remove ex

Page 228 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual 11 ENGINE OVERHAUL Cooling System (1) Install switch. (2) Install engine coolant lighten sensor to 7 Nm (5 torque. Overflownipple Pressure cap Impeller TSB Revision O-ring (3) Plac

Page 229 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE OVERHAUL Fuel and Intake manifoldFUEL AND EMISSION CONTROL PARTS REMOVAL (1) Remove screws attaching EGR tube to intake mani fold. (2) Remove EGR valve mounting screws. Remove EG

Page 230 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE, OVERHAUL Fuel and Emission Control,, INSTALLATION (1) Apply a light coating of clean engine,, oil to the upper O-ring. (2) Install injector in cup on fuel (3) Install

Page 231 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE OVERHAUL Manifold EGR tube INTAKE MANIFOLD (1) Remove intake air temperature sensor. (2) Remove manifold absolute pressure (MAP) sensor mount- ing screws. (3) Remove manifold

Page 232 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE OVERHAUL EGR tubeINSTALLATION11661966616 (1) Install new manifold gasket. DO NOT APPLY SEALER. (2) Set manifold in place. Tighten retaining fasteners, starting at center an
Load next 8 pages
Page:   < prev 1-10 ... 193-200 201-208 209-216 217-224 225-232 233-240 241-248 249-256 257-264 ... 2104 next >
warning lightsspark plugskey batterymileagefuel tank capacitypower steering
Popular search:
stop startheight adjustmenttransmission oilairbaghood releasejack pointsoil change