Page 1889 of 2103
BODY
TROUBLESHOOTING
SymptomImproper closure
Difficult locking and unlocking
Uneven body clearance
UnevenProbable cause Remedy
Striker and latch not properly aligned Adjust the al ignment
Striker and latch not properly aligned
Adjust the alignment
Incorrectly installed Adjust the installation of
Incorrect bumper height Adjust the bumper height
TSB Revision
Page 1890 of 2103

B O D Y
REMOVAL AND INSTALLATION
7
1. damper (upper)
2. damper (lower)
3. gas spring
4. opening weatherstrip
and hinge removal
steps
l Washer tube (Refer to GROUP 51 Rear Wiper and Washer.)
l trim, side trim (L.H.)
and rear side trim (Refer to GROUP
Trims.)
3. gas spring5. Connection for wiring harness6.l Headlining (Refer to GROUP Headlining.)7. hinge
lock release cable and
handle removal steps
l Scuff plate (driver’s side)
(Refer to GROUP
Trims.)
8. Release handle cover
9.
lock release handle Quarter trim, rear side trim andrear end trim (Refer to GROUP Trims.)10. latch
11. lock release cable ,
, ,
of clearance around
iftgate
Adjustment of step and striker linkage
latch removal steps
l Rear end trim
(Refer to GROUP
Trims.)
10. latch
striker removal steps
l
trim
(Refer to GROUP Trims.)
12. striker
lock cylinder removal steps
l Rear end trim
(Refer to GROUP
Trims.)l Rear combination Iiht( R e f e r t o G R O U54 RearCombination Liaht and Back-up Light.)13. Retainer
14. lock cylinder (Vehicles with-out theft-alarm system)
15. lock cylinder switch(Vehicles with theft-alarm system)
Caution1.Never try to disassemble the gas or burnit.2.Always bore a hole in the gas spring to release the interior gas before the spring discarded.
TSB Revision
Page 1891 of 2103
BODY __.
LUBRICANT POINTS
0 0 0 0 3 8 1 1
INSPECTION
LUGGAGE COMPARTMENT LIGHT SWITCH CONTINUITY
CHECK (INCLUDING LATCH)
Switch positionTerminal No.
12 (Ground)
ON (Latch open)
0 0
OFF (Latch shut)
LOCK CYLINDER SWITCH CONTINUITY CHECK
Switch positionTerminal No.
12
LOCK00
Neutral (OFF)
UNLOCK
TSB Revision
Page 1892 of 2103
TRUNK LID
B O D Y Trunk Lid
TROUBLESHOOTING
SymptomProbable cause Remedy
Improper closure Striker and latch not properly aligned
Adjust the alignment
Difficult locking and unlocking.
Uneven body clearance Incorrectly installed trunk lid
Adjust the installation of trunk lid
Uneven height Incorrect trunk lid bumper height Adjust the trunk lid bumper height
TSB Revision
Page 1893 of 2103
BODY Trunk Lid
TRUNK LID
REMOVAL AND INSTALLATION
of trunk lid step
trunk lid striker linkageAdjustment of clearance
around trunk lid
1. Bumper
2. Trunk lid striker
3. Trunk lid opening weatherstrip
Trunk lid latch removal steps
l Rear end trim (Refer to GROUP
Trims.)4. Trunk lid latch
Caution1.Never try to disassemble the gas spring
or burn it.
2.Always bore a hole in the gas spring to release
the interior gas before the spring is discarded.
0 0 0 0 4 7 5 2
Trunk lid gas spring removal steps 6. Lock cover
7. Trunk lid gas spring
8. Ball joint
Trunk lid removal steps
5. Harness connector
6. Lock cover
7. Trunk lid gas spring
9. Trunk lid hinge
10. Trunk lid
TSB Revision
Page 1894 of 2103
BODY Trunk Lid
Slit
I
I
Trunk lid opening weatherstrip
Trunk lid
in.)
Bumper
REMOVAL SERVICE POINT
LOCK COVER
a flat-tip screwdriver, etc., into the slit, and r emove
the lock cover.
INSTALLATION SERVICE POINTS
TRUNK LID OPENING WEATHERSTRIP
INSTALLATION
(1)Install the trunk lid opening weatherstrip so that the marked
part is at the position shown in the illustration.
(2) Install so that the notch on the trunk lid open ing
weatherstrip is approximately at the center of the panel
notch shown in the illustration.
BUMPER INSTALLATION
Install the bumper as shown in the figure.
TSB RevisionI
Page 1895 of 2103
BODY Trunk Lid Lock Release Handle and Cable
REMOVAL AND INSTALLATION
Trunk lid lock release handleremoval steps
1. Release handle cover2. Retainer3. Lock cylinder
l Scuff plate (Driver’s side)
(Refer to GROUP
Trims.)
l Front seat (Driver’s side)
(Refer to GROUP
Front seat.)
4. Trunk lid lock release handle
. .
Adjustment of trunk lid step
frunk lid striker linkage .
Trunk lid lock cableremoval steps
1. Release handle cover
l Scuff plate (Driver’s side)
(Refer to GROUP
Trims.)
l Front seat (Driver’s side)
(Refer to GROUP
Front seat.)
4. Trunk lid lock release handlel Quarter trim, lower (L.H.) and luggagecompartment side trim (Refer to GROUP 5. Trunk lid latch
6. Trunk lid lock release cable
TSB Revision
Page 1896 of 2103

42-72BODY Entry System
TROUBLESHOOTING
INSPECTION CHART FOR TROUBLE SYMPTOMS
Trouble symptomNo doors can be
locked or unlocked.
Probable causeRemedy
The indicator light of the transmitterl
does not illuminate when the trans-
Dead transmitter battery Check according to
lMalfunction of transmitter Flow Chart A
mit switch is pressed. (Refer to
A transmission signal is being sentl
from the transmitter (indicator light Malfunction of central Check according to
door locking system
Flow Chart
luminates) but the door lock does notlMalfunction of receiver
operate.l M a l f u n c t i o n o f (Refer to
ECU
Not all of the doors can be locked or unlocked.lMalfunction of door lock Check according to
actuatorF l o w C h a r t
(Refer to
All doors can be locked and unlocked with the trans mitter, butlMalfunction of receiver
the dome light and foot light do not flash or illuminate. Check according to
the dome light operation is normal when a door is openedFlow Chart
and closed.) (Refer to
No secret code can be registered.l
Malfunction of receiver
Malfunction of scan tool
Check according to
Flow Chart
(Refer to
When all doors are locked with the transmitter, the theft-alarmlMalfunction of receiver
system is not set. (The SECURITY indicator doesn’t illuminate,Check according tol
the alarm doesn’t function.)
alarm
Malfunction of ETACS- Flow Chart
ECU.
(Refer to
the PANIC switch of the transmitter is pressed, th e head-lMalfunction of receiverights do not flash and the horns do not sound. (How ever, theCheck according tol
heft-alarm functions normally.)
t-alarm
em>
Malfunction of ETACS- Flow Chart
ECU to
TROUBLE SYMPTOM INSPECTION CHART
A The indicator light of the transmitter does not illuminate when the transmit switch is pressed.
Replace the batteries (Refer to
YES
Does the indicator light illuminate when the batter ies are replaced?
Replace the transmitter.
TSB Revision