Page 1425 of 2103
TRANSAXLE OVERHAUL
output gear bolt and coned lock washer.
.
Gear Puller with Bolts and
Thrust Button to output gear. Turn puller center
bolt clockwise to remove gear.
output gear and shim.
Bearing and Gear Puller Button
on output gear bearing to remove bearing.
gear carrier assembly.
TSB Revision
Page 1426 of 2103
AUTOMATIC TRANSAXLE OVERHAUL”-’ Transaxle
and
Low/reverse
gear carrier bearing with-, Rearing
and Button
center bolt of Spring Compressor Spring
Compressor
Disc 0 to. assemble
low/reverse spring compressor tool.
. compressor tool as shown. Compress
low/reverse piston assembly.
Position Spring Compressor to
to snap ring.
snap ring with snap ring pliers.
low/reverse. piston return spring.
TSB Revision
Page 1427 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Transaxle
out park rod bracket anchor shaft with
hammer and drift.
Drift
Park rod bracket anchor shaft
,
guide bracket shaft and plug.
out guide bracket pivot with pliers.
pivot shaft bracket.
l Guide bracket’ (assembled)
Guide
bracket
-r at c h et
TSB Revision
Page 1428 of 2103
AUTOMATIC TRANSAXLE OVERRAUL , , ,
,Guide bracket
Split sleeve
.
Spacer
IStepped
spacer
spring
Low/reverse piston
Lip seal
Low/reverse ,, Screwdriver
retainer
screws
l
Guide bracket (disassembled)
low/reverse clutch piston.
screws low/reverse
piston retainer.
low/reverie clutch piston retainer gasket.
TSB Revision
Page 1429 of 2103
AUTOMATIC TRANSAXLE OVERHAUL
out “output a steel
h a m m e r .
Drift bearing cup all the way,.
Remover 1.
TSB Revision
Page 1430 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Transaxle
REASSEMBLY
. . .
(1) Install both output bearing Bearing
and wrenches.
(2) Install low/reverse clutch
Be sure to align gasket holes.. .
(3) Install low/reverse clutch piston retainer.
(4) install screws attaching low/reverse clutch piston
retainer.
(5) Install low/reverse clutch piston.
TSB Revision
Page 1431 of 2103
AUTOMATIC TRANSAXLE OVERHAUL
Guide bracketI
Split sleeve
.
bracket anchor
ide
Install pivot shaft and guide bracket.
Caution
Be sure that guide bracket split touch
the rear of the case.
l Guide bracket (disassembled)
l Guide bracket (assembled)
(7) Install guide bracket anchor shaft and
(8) Install park rod guide bracket anchor shaft wit h a
and drift.
,
TSB Revision
Page 1432 of 2103
(lO)Use center bolt of Spring Compressor Spring
Compressor
and Disc 0 to assemble
low/reverse spring compressor tool.
,
,
,
(11) Install compressor tool to transaxle as shown to compress
low/reverse piston assembly.
AUTOMATIC TRANSAXLE OVERHAUL
(9) Install low/reverse piston return spring. ,
.
snap ring with snap ring pliers.
NOTE
Be sure to place the opening between-spring
,
rear carrier bearing cone,,. press onto rear carrier
2using Installer Cap, 2,
and Installer Adapter ,
3
New bearing
TSB Revision