Page 1305 of 2103
A U T O M A T I C T R A N S A X L E
OVERHAUL Transaxle
the differential cover
the differential
. .
the differential outer’
race.
,,
the differential assembly.. .
out the end clutch’ installation
move the cover holder and end
the end assembly.
TSB Revision
Page 1306 of 2103
AUTOMATIC TRANSAXLE
OVERHAUL
-Transaxle
the thrust plate.
the end clutch hub.
t h r u s t b e a r i n g
NOTE
It may be stuck to the and clutch
out the end clutch shaft.
the idler gear cover mounting then’
the idler gear cover and gasket.
the bolt stopper and remove the bolt.
TSB Revision
Page 1307 of 2103
AUTOMATIC TRANSAXLE
OVERHAUL
the special tool, pull out the. shaft and
remove the idler gear and race.
the spacer.
the oil pump bolts.
. ,
the special tool to remove the pump.‘
,
t h r u s t w a s h e r .
,
TSB Revision
Page 1308 of 2103
AUTOMATIC TRANSAXLEOVERHAUL -Transaxle
the input shaft and remove the front
and rear clutch assembly together.
thrust bearing
the clutch hub.
NOTE
. .
The thrust race may be to the clutch ‘hub.
thrust bearing
,
the drum.
TSBRevision
Page 1309 of 2103
TSB
t h e .
the servo cover cover
t h et h e
. .
, ,
,, ,
special tool, push “in the
remove the snap . .. .
t h e
Page 1310 of 2103
-Transaxle
plug, then remove the
the snap ring.
the special tool, remove the. ‘support.
TSB Revision
the sun gear forward to-
gether.
.
..
the carrier assembly.
Page 1311 of 2103
the wave spring, return spring, reaction
brake discs, and brake plates.
‘the screws and rear bearing retainer.
the snap ring and the output
a s s e m b l y .
the output bearing retainer mounting
then remove the output bearing retainer and outer ‘race.,
the transfer shaft.
TSB Revision
Page 1312 of 2103
-Transaxle
Differential
bearing
retainer
a sliding hammer, etc., to remove the outer race.
all oil seals. ,
,
REASSEMBLY
(1)Using the special tool, install the oil seals to th e differential
bearing retainer and transaxle case.
(2) Use the special tool to press fit the
into the’
transaxle case.
(3) Install the transfer shaft.
(4) Place solder with a length of approximately 10 mm
in.) and diameter of 1.6 mm in.) on the output bearing
retainer at the position shown in the diagram and install
the outer race.
TSB Revision