1990 MITSUBISHI SPYDER Service Repair Manual

Page 2081 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual   and  Tension 
  Engine  (Non-turbo)>
Bolt mm   in.)]
Socket
Deep  socket
(14  mm 
  in.)]
TSB
  HUB  REMOVAL
(1)  Remove  the  clutch  hub  mounting  bolt.
(2) Tighten a 
 mm  in.) bolt into  the ho

Page 2082 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual 55-42
Pin
Main  unit  of conditioningcompressor
Compressor  side
connector
2
  CLUTCH  COIL  INSTALLATION
Set  the  clutch  coil  pin  in  the  compressor  housing  n otch,  and
install the clutch coi

Page 2083 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual HIGH-PRESSURE  RELIEF   CHECK
The high-pressure relief valve is a safety feature which re-
leases  of  the   inside  the  system  into  the 
sphere  when  the  high-pressure:  level  exceeds  3,740  (

Page 2084 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual   Engine  (Turbo)  and   Engine>
Refrigerant  Discharging  and  Charging(Refer  to 
Piping  or  hose  connection
1.  Liquid  pipe  A
2.  Liquid  pipe 
3.  Liquid  pipe   4.  Receiver  assembly
5. Dual

Page 2085 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual   Engine  (Non-turbo)>
Pm-removal  and  Post-installation  OperationRefrigerant Discharging and Charging 
(Refer  to CAUTIONPlug  refrigerant  lines  to  prevent when  disconnecting  them.
Piping  or

Page 2086 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual REMOVAL  AND  INSTALLATION
  Engine  (Turbo)  and   Engine>
  and  Post-installation  OperationRefrigerant Discharging and Charging
(Refer  to CAUTIONPlug refrigerant lines to when  disconnecting  the

Page 2087 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual Pipingor  hose  connection
Condenser removal steps1. Radiator fan motor assembly (Refer  to  GROUP  14 
  Radiator.)
2. Condenser fan motor and shroud
assembly  Upper  insulator  installation  bolts
8

Page 2088 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual HEATER,  AIR Condenser  and
  Condenser  Fan’  Motor
TurboNon-turbo
REMOVAL  SERVICE  POINT  ,
  REMOVAL, 
Move  the  radiator  to  the  engine  side  and  then  lift up  the
condenser  to  remove