1990 MITSUBISHI SPYDER Service Repair Manual

android auto fuel filter location rear view mirror brake fluid clock airbag off

Page 593 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE (TURBO)
AND
ENGINE> Troubleshooting
INSPECTION PROCEDURE 17
Probable causeI
[Comment]l Malfunction of the system
Malfunction of the system is suspected.
Are diagnostic troubl

ENGINE (TURBO)
AND
ENGINE> Troubleshooting
INSPECTION PROCEDURE 17
Probable causeI
[Comment]l Malfunction of the system
Malfunction of the system is suspected.
Are diagnostic trouble codes output
YESRefer to INSPECTION FOR DIAGNOSTICTROUBLE CODES.
Check theidle air control motor for operation sound Engine (Refer to Check the idle air control motor for operation soun d Engine>. (Refer to
SCAN TOOL Data list
14 Throttle position sensor (Refer to
OK
Check the idle control system malfunction (Refer t o INSPECTION PROCEDURE FOR DIAGNOSTIC TROUBLE CODE
Check the throttle position circuit malfunction (Refer to PROCEDURE FOR DIAGNOSTIC TROUBLE 20.)
NG,
SCAN TOOL Data list Check closed position switch system.
26 Closed throttle position switch (Refer to (Refer to INSPECTION PROCEDURE FOR DIAGNOSTICTROUBLE CODE .
. .
Clean the throttle valve area. (Refer to
INSPECTION PROCEDURE 18
Poor acceleration Probable cause I
[Comment]
Defective ignition system, abnormal air-fuel ratio, poor compression pressure, etc. are l Malfunction of the Ignition system Malfunction of air-fuel ratio control l Malfunction of the fuel supply system Poor acceleration
l C l o g g e d e x h a u s t s y s t e m
l Malfunction ‘of turbocharger system .
SCAN TOOL DTC
Are diagnostic trouble codes output
YESRefer to INSPECTION CHART FOR DIAGNOSTICTROUBLE CODES.
Check the injectors for opNG
(Refer to PROCEDURE FOR DIAGNOSTIC TROUBLE
OK
Check the ignition timing. Engine (Turbo)>
(Refer to GROUP A On-vehicle Service.)
Check the ignition timing. Engine>
Check that the crankshaft position sensor and timi ng belt cover are
installed
(Refer to GROUP On-vehicle Service.)
OK
Scan tool: Inspection when hesitation. stumble or poor acceleration occur. (Refer to INSPECTIONPROCEDURE 42.)I
OK
Check the fuel pressure. (Refer to
OK
Check the following items.
l Check the ignition coil, spark plugs, spark plug ca bles.
l Check supercharging pressure.
l Check intake charge pressure control system.
l Check rotating resistance of turbocharger turbine w heel. (Does the wheel rotate smoothly?)
l Check the compression pressure.
lCheck the fuel filter or fuel for clogging.
l Broken air intake hose
Clogged air cleaner
l Clogged exhaust system
Revision

Page 594 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE (TURBO)
AND ENGINE> Troubleshootina
INSPECTION PROCEDURE 19
Surge
Defective ignition system, abnormal air-fuel are suspected.
, .
l Malfunction of ignition systeml Malfuncti

ENGINE (TURBO)
AND ENGINE> Troubleshootina
INSPECTION PROCEDURE 19
Surge
Defective ignition system, abnormal air-fuel are suspected.
, .
l Malfunction of ignition systeml Malfunction of’ ‘ratio ‘control system l Malfunction of the EGR solenoid system
Are diagnostic trouble codes output
YES ,
Refer to INSPECTION CHART FOR DIAGNOSTICTROUBLE CODES.
.
Check the injectors for opNG
(Refer to PROCEDURE FOR TROUBLE
OK
Check the ignition timing. Engine (Turbo)> Check that the crankshaft position sensor and are properly.(Refer to GROUP On-vehicle Service.)
Check the Engine>
(Refer to GROUP On-vehicle Service.)
Scan Tool: Inspection when surge occurs. (Refer to INSPECTION PROCEDURE 43.)
OK
Check the fuel pressure. (Refer to
OK
Check the following items.
l Check the ignition coil, spark plugs, spark plug ca bles.
l Check the EGR system.
l Check the
waste actuator.
INSPECTION PROCEDURE 20
Knocking Probable cause
[Comment]l Defective knock sensor ,
In cases such as the above, the cause is probably t hat the detonation control is defective or thel heat the
heat value of the spark plug is inappropriate.. .
YESRefer to INSPECTION CHART FOR’ ‘DIAGNOSTIC Are diagnostic trouble codes output TROUBLE CODES.
NO
NODoes knocking occur when driving with the sensor Check the knock sensor 1 circuit malfunction (Refe r INSPECTION PROCEDURE FOR CODE’At this time, use the scan tool to check if the timing isretarded compared to when the knock sensor connecto ris connected.
YES
Check the following items.
l Spark plugs heat range
l Check if foreign materials (water, alcohol, etc.) g ot into fuel.
INSPECTION PROCEDURE 21
DieselingProbableI
[Comment]
Fuel leakage from injectors is suspected.l Fuel leakage from injectors
Check the injectors for fuel leakage.
TSB Revision

Page 595 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE (TURBO)
AND ENGINE> Troubleshooting
INSPECTION PROCEDURE 22
Too high CO and HC concentration when idling
[Comment]Malfunction of the ratio
Abnormal air-fuel ratio is susp

ENGINE (TURBO)
AND ENGINE> Troubleshooting
INSPECTION PROCEDURE 22
Too high CO and HC concentration when idling
[Comment]Malfunction of the ratio
Abnormal air-fuel ratio is suspected.
SCAN TOOL Are diagnostic trouble codes output
N O
YES Refer to INSPECTION CHART FOR DIAGNOSTICTROUBLE CODES.
Check the ignition timing. Engine (Turbo)>NG
(Refer to GROUP On-vehicle Service.) Check that the crankshaft position sensor and belt installedCheck the ignition timing. Engine>(Refer to GROUP 11 On-vehicle Service.)
OK
NGSCAN TOOL Data list
21 Engine coolant temperature sensor. Check the engine coolant temperature malfunction. (Refer to
(Refer to INSPECTION PROCEDURE FOR DIAGNOSTIC
TROUBLE CODES
OK
SCAN TOOL Data listNG Check the intake air temperature (Refer to
13 Intake air temperature sensor (Refer to INSPECTION PROCEDURE FOR DIAGNOSTIC
OK TROUBLE CODE
SCAN TOOL Data list
25 Barometric pressure sensor (Refer to
OK
Check the pressure circuit malfunction. INSPECTION PROCEDURE FOR DIAGNOSTIC TROUBLE CODE
SCAN TOOL Data listNGCheck the oxygen sensor circuit malfunction (bank sensor 2). (Refer59 Heated oxygen sensor (rear) (Refer to to INSPECTION PROCEDURE FOR DIAGNOSTIC
l Transaxle gear TROUBLE CODE ranae l Driving with the throttle wide open
O K :
OK
SCAN TOOL Data list NG
Heated oxygen sensor (front) (Refer to OK: 1,000 when racing suddenly
OK
SCAN TOOL Data list11 Heated oxygen sensor (front) (Refer to O K : and
Check the oxygen sensor circuit malfunction (bank 1 sensor 1). INSPECTION PROCEDURE FOR DIAGNOSTICTROUBLE CODE
alternately when idling.
NG
Check the fuel pressure. (Refer to
Check the following items.
l Check the injectors for operation sound.
l Check the injectors for fuel leakage.
l Check the ignition coil, spark plugs, spark plug ca bles.
l Check the compression pressure.
l Check the positive crankcase ventilation system.
l Check the evaporative emission control system.
l Check the
system.I
Check trouble symptom.
Replace the three-way converter.
TSB Revision

Page 596 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE (‘TURBO)
AND ENGINE>
INSPECTION PROCEDURE 23
,
Generator output voltage is low (approx.
[Comment]
The cause may be a malfunction of the generator or one of the probl

Page 597 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE (TURBO)
AND ENGINE> Troubleshoot&j
INSPECTION PROCEDURE 24
Transient, mass emission tailpipe test test failed
[Comment]
The test is failed if the air/fuel ratio is not co

Page 598 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE (TURBO)
AND ENGINE> Troubleshooting
Has the engine warmed up sufficiently when the exhaust gas is
tested? (Check with owner.)Let the engine warm up sufficiently before

ENGINE (TURBO)
AND ENGINE> Troubleshooting
Has the engine warmed up sufficiently when the exhaust gas is
tested? (Check with owner.)Let the engine warm up sufficiently before testing the exhaust gas.
,
l Check all vacuum hoses and connectors.
l Check electrical wires and connectors for obvious p roblems.
l Check the exhaust system for missing Repair
No
Check the ignition timing Engine (Turbo)>.
Check the ignition timing Engine>.
(Refer to GROUP
Refer to INSPECTION CHART TROUBLE CODE.
NG Check that the crankshaft position sensor and timi ng belt cover
are properly.
SCAN TOOL list
21 Engine coolant temperature sensor
(Refer to P.
Check the engine coolant temperature sensor circui t malfunction.
OK
NGCheck the intake air temperature sensor circuit mal function. (Referto INSPECTION PROCEDURE FOR DIAGNOSTIC
TROUBLE CODE
25 Barometric pressure sensor (Refer to
IOK
NG Check the barometric pressure sensor circuit (Refer
to INSPECTION PROCEDURE FOR DIAGNOSTIC
TROUBLE CODE
, N G
SCAN TOOL Data list Check the oxygen sensor circuit malfunction (bank 1 sensor 2).
59 Heated oxygen sensor (rear)’ (Refer to
l Transaxle: gear range TIC TROUBLE CODE l Drive with wide open throttleO K : 6 0 0 1 0 0 0
TSB Revision
OKNGSCAN TOOL Data list Check the oxygen sensor circuit malfunction (bank 1 sensor 1).
11 Heated oxygen sensor (front) (Refer to
OK: 600 1000 when racing suddenly TIC TROUBLE CODE
OK
OK
SCAN TOOL Data list Check the EGR system. (Refer to GROUP 17 Emission Control11 Heated oxygen sensor (front) (Refer to System)OK: 0 400 and 600 1000 alternately when idling
and 2500 OKNGMeasure the CO
Check the fuel pressure. (Refer to
sensor
l Check the injector for fuel leakages.
Check troub symptom. l Check the injectors for operation sound.
l Check the
spark plugs, spark plug cables.l Check the compression pressure. Replace the three-way catalytic converter.
l Check the positive crankcase ventilation system.
l Check the evaporative emission control system.

Page 599 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE
AND ENGINE> Troubleshooting,
INSPECTION PROCEDURE 25
Purge flow test of the evaporative canister test failed
[Comment]
The test is failed if there is a blockage in the

Page 600 of 2103

MITSUBISHI SPYDER 1990 Service Repair Manual ENGINE (TURBO)
AND ENGINE>
INSPECTION PROCEDURE 27
Power supply system and ignition systemP r o b a b l e
[Comment]l Malfunction of the ignition switchWhen an ignition switch ON sign

Load next 8 pages

Page: < prev 1-10 ... 561-568 569-576 577-584 585-592 593-600 601-608 609-616 617-624 625-632 ... 2104 next >

brakes key fob battery 4WD dead battery open trunk ad blue audio