1990 MITSUBISHI SPYDER mileage

GENERAL Lubrication arid Maintenance,
00100120067
Maintenance and lubrication service recommenda-
tions have been compiled to provide maximum
protection for the vehicle owner’s investment
against all reasonable types of driving conditions.
Since these conditions vary with the individual ve-
hicle owner’s driving habits, the area in which the
vehicle is operated and the type of to which
the vehicle is subjected, it is necessary to prescr ibe
lubrication and maintenance service on a time fre-
quency as well as mileage interval basis.
Oils, lubricants and greases are classified and
graded according to standards recommended by
the Society of Automotive Engineers (SAE), the
American Petroleum Institute (API) and the National
Lubricating Grease Institute (NLGI).
MAINTENANCE SCHEDULES
Information for service maintenance is provided
under “SCHEDULED MAINTENANCE TABLE”.
Three schedules are provided; one for “Required
Maintenance”, one for “General Maintenance” and
one for “Severe Usage Service”. Item numbers in the “SCHEDULED MAINTE-
NANCE TABLE” correspond to the item
in the “MAINTENANCE SERVICE” section.
SEVERE SERVICE
Vehicles operating under severe service conditions
will require more frequent service. Component service information is included in ap-
propriate units for vehicles operating under one
or more of the following conditions:
1. Police, taxi, or commercial type operation
2. Operation of Vehicle
(1) Short-trip operation at freezing temperature
(engine not thoroughly warmed up)
(2) More than 50% operation in heavy city traf-
fic during hot weather above
(3) Extensive idling
(4) Driving in sandy areas
(5) Driving in salty areas
(6) Driving in dusty conditions
ENGINE OIL
Either of the following engine oils should be used:
(1) Engine oil displaying EOLCS certification mark
(2) Engine oil conforming to the API classification SH
or ECII.
For further details, refer to “LUBRICANTS SELEC-
TION” section.
Caution
Test to EPA have shown
laboratory animals develop skin after
prolonged contact with used engine oil. Accord-
ingly, the potential exists for
to
a number:, of skin disorders, including
from such exposure to used
Care should be taken, when changing
engine oil, to minimize the
of exposure time to used your
skin. Protective clothing and that
be penetrated by worn.
should be thoroughly with soap
use waterless hand remove,
any used engine oil. Do not use gasoline, thin- ners, or solvents.
GEAR LUBRICANTS
The SAE grade number indicates
of Multi-purpose Gear Lubricants.
The API classification system
cants in terms of gear lubricants
conforming to API
or ‘with a
of SAE are recommended for
transaxle.
LUBRICANTS GREASES
Semi-solid lubricants bear the
designation
and are further classified as grades 0, 1, 2; 3 etc .
Whenever “Chassis Lubricant” is specified, Multi-
purpose Grease,
grade 2, should be used.
FUEL USAGE
Your car must use unleaded
This car has a fuel filler tube especially
to accept only the smaller-diameter unleaded gaso- line dispensing nozzle.
Caution
Using leaded gasoline in your car will damage
the catalytic converter and oxygen sensor, and
affect the warranty coverage validity.
Your car is designed to operate on premium
leaded gasoline having a minimum octane rating
of 91 or 95 RON (Research Octane
If premium unleaded gasoline is not
leaded gasoline having a octane rating of 87,
91 RON (Research Octane Number) may be used. In this case, the performance and fuel consumption
will suffer a little degradation.
Gasolines Containing Alcohol
Some gasolines sold at service stations contain
alcohol, although they may not be so identified.
TSB Revision

E N G I N E
Scan tool 46
Code General scan toolEGR System Failure c a u s e No.
32
[Comment]Backgroundl EGR valve
l Once per vehicle trip the PCM monitors the EGR syst em fiow rate.. t u b e l harness and lIf the flow rate is above or below the acceptable l
imits, the PCM stores a’ diagnostic
l Vacuum hoses’ failed
trouble code.
Range of Check
l Engine temperature is greater than
l More than three minutes have passed since start-up.
l Engine is between 1952 and 2400.
l MAP voltage is between and 2.70.
l TPS voltage is between 0.6 and
Vehicle speed exceeds 3 mph. Short term fuel compensation value is exhibiting l ess than During air/fuel ratio closed loop control ConditionThe measured change in the short-term fuel compensa tion value shift during the test is
less than 7.4% or greater than 20.5%.
Check the idle running.
l Idle running after warming up
lRemove the vacuum hose from the EGR valve nipple an d plugit.lConnect a hand vacuum pump to the EGR valve nipple, and
apply a 12 (3.5 of vacuum.
OK: Idle speed becomes unstable or the engine stalls.
NG.lCheck the EGR valve and replace if lCheck the EGR tube for and clean or it . .
OK
OK
Repair
Check the EGR solenoid circuit. (Refer to INSPECTIONP R O C E D U R E F O R D I A G N O S T I C T R O U B L E C O D E S
Scan tool 46
Code General scan tool PCM Failure
No.SRI Mile Not Stored
62
Revision
[Comment]lUnsuccessful attempt to update service reminder ind icator (SRI or mileage in the
control module EEPROM.
Replace the PCM.I
Probable cause

Emission
ENGINE AND EMISSION CONTROL
GENERAL INFORMATION
The emission control system consists of the following sub-systems:
l Positive crankcase ventilation system
l Evaporative emission control system
l Exhaust emission control system
SERVICE SPECIFICATIONS
Evaporative emission purge solenoid coil resistance
[at
Electric EGR transducer solenoid coil resistance
[at
Standard value
25-35
.
2 5 - 3 5
TROUBLESHOOTING17300070052
Symptom Probable causeRemedy,
Engine will not start or
Vacuum hose disconnected or damaged. replace is hard to start.
The EGR valve is not replace
Malfunction of the evaporative emission purge or solenoid.
Rough idle or engineThe EGR valve is not closed. Repair or replace
stalls.Vacuum hose disconnected or damaged.Repair or replace
Malfunction of the crankcase ventilationReplace
valve.
Malfunction of the purge control system.
Checkthe system; if there is a prob-
lem, check its component
Engine hesitates or
poor acceleration.
Excessive oil
sumption.
Poor fuel mileage.
Malfunction of the exhaust gas recirculation
system.
Positive crankcase ventilation line clogged.
Malfunction of the exhaust gas recirculation
system.
Check the system; if there is a
check its component parts.
Check positive crankcase ventilation
system.
Checkthe system; if there is a
check its component parts.
TSB Revision

(Turbo) 2.41 Engines
GENERAL INFORMATION
The emission control system consists of the following sub-systems:
l Positive crankcase ventilation system
l Evaporative emission control system
l Exhaust emission control system
SERVICE SPECIFICATIONS
Evaporative emission purge solenoid coil resistance
[at
Standard value
36-44
EGR solenoid coil resistance [at 36-44
SPECIAL TOOL
ToolTool number and name
Supersession Application
700Checking the purge control
system
TROUBLESHOOTING
SymptomProbable cause Remedy
Engine will not start or Vacuum hose disconnected or damaged. Repair or
is hard to start.
The EGR valve is not closed. Repair or replace
Malfunction of the evaporative emission purge Repair or replace
solenoid.
Rough idle or engine
stalls.The EGR valve is not closed.
Vacuum hose disconnected or damaged.
Malfunction of the positive crankcase ventilation
valve. Repair or replace
Repair or replace
Replace
Malfunction of the purge control system.
Engine hesitates or
poor acceleration.
Excessive oil
sumption.
Poor fuel mileage.
Malfunction of the exhaust gas recirculation
system.
Positive crankcase ventilation line clogged.
Malfunction of the exhaust gas recirculation
system. Check the system; if there
a prob-
lem, check its
parts.
Check the system; if there is a
check its component parts.
Check positive crankcase ventilation
system.
Check the system: if there is a
check its component parts.
TSB Revision