Page 1465 of 2103
AUTOMATIC OVERHAUL Input Clutches
, of input clutch assembly is now complete.
TSBRevision
Page 1466 of 2103
AUTOMATIC TRANSAXLE’
Before removing any transaxle plug all
openings and thoroughly clean preferably
by steam.Cleanliness and
assembly cannot be.
When
each part should be washed suitable dried
by compressed air. Do not
All
mating surfaces in the transaxles are accurately ma chined;
therefore, careful
of all parts must be to
avoid nicks or burrs.
all as they removed
for reassembly identification.
Oil pan bolts
DISASSEMBLY
(1) Remove oil pan bolts.
(2) Remove oil pan.
(3) Remove oil filter.
TSB Revision
Page 1467 of 2103
(4) Remove, valve body attaching bolts (18).
I
Manual
shaft
seal
(5) Using a screwdriver, push park sprag rollers aw ay from
guide bracket.
(6)Remove valve body.
(7) Remove transaxle range sensor
screw.
(8) Remove manual shaft seal.
TSB Revision
Page 1468 of 2103
Transaxlerange
sensor
clutchcheck
Retainers
(9) Slide transaxle range sensor up the manual shaf t and
remove.,
(lO)Remove accumulator retaining plate screws (2).
Remove the upper valve body.
(ll)Remove separator plate from transfer plate. Rem ove O/D
clutch check ball and oil screen.
.
thermal valve.
check balls and retainers.
Check ball 75
TSB Revision
Page 1469 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Valve Body
T/C control valve
spring plug
Regulator
valve spring
76
r e t a i n e r p l a t e w i t h
6.
Remove torque converter control valve and torque
converter clutch valve.
retainer
plateusingInstaller/Remover
17.
(15) Remove
Removeregulator valve.
TSB Revision
Page 1470 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Valve Body
SPRINGS AND VALVES IDENTIFICATION
Roostercomb.Manual shaft
Retainer
-4
Rivet
Solenoid switch valve
Retainer
T/C control
valve
Torque
clutch valve Manual valve
Insulator
check ball
accumulator
Valves removed
TSB Revision
Valves installed
76
Page 1471 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Body
Retainer
Check ball
REASSEMBLY
(1) Install regulator valve.Install retainer plate using
7.’
(2) Install torque converter control valve and torq ue converter
clutch valve.
Install dual retainer plate withInstaller/Remover
6.
(3) Install check balls and retainers.
(4) Install thermal valve.
(5) Install separator plate from transfer plate. Install O/D clutch check ball and oil screen.
TSB Revision
Page 1472 of 2103
AUTOMATIC TRANSAXLE OVERHAUL Body
accumulator plate (2).
Manual
shaft
seal
(7) Slide transaxle range down the manual shaft
(8) Install manual shaft seal.
Install transaxle range screw.. . .
.
detent as shown.