2001 NISSAN ALMERA N16 Electronic Repair Manual

Page 1721 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual RemovalNJBR0123
SBR631E
1. Remove parts shown below.
+Air duct, air cleaner case (upper)
+Engine cover
+Rocker cover
+Exhaust manifold cover
+EGR tube
2. Disconnect vacuum hose from vacuum pump.
3. Re

Page 1722 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual SBR633E
InstallationNJBR01241. Assemble vacuum pump and cylinder head rear cover
assembly, referring to ªComponentº in the next page.
2. Install vacuum pump and cylinder head rear cover assembly to

Page 1723 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual ComponentNJBR0126
SBR612E
SBR613E
DisassemblyNJBR0136Disassemble the components, referring to the ªComponentº, then
remove vacuum pump.
CAUTION:
Do not disassemble vacuum pump. (Do not loosen three

Page 1724 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual lightly [approximately 9.8 N (1.0 kg, 2.2 lb)].
6. Remove thickness gauges (2).
+Leave sprocket retaining bolts (M6) until installation.
VACUUM PUMP
Assembly (Contd)
BR-26

Page 1725 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual ComponentNJBR0030
NBR429
1. Main pin
2. Pin boot
3. Torque member fixing bolt
4. Torque member
5. Shim cover
6. Inner shim7. Inner pad
8. Pad retainer
9. Outer pad
10. Outer shim
11. Connecting bolt
1

Page 1726 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual SBR976B
SBR932C
1. Remove master cylinder reservoir cap.
2. Remove pin bolt.
3. Open cylinder body upward. Then remove pad with retainers,
inner and outer shims.
Standard pad thickness:
11 mm (0.43 in

Page 1727 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual PistonNJBR0033S0102CAUTION:
Piston sliding surface is plated. Do not polish with emery
paper even if rust or foreign materials are stuck to sliding
surface.
Check piston for score, rust, wear, damage

Page 1728 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual SBR574
AssemblyNJBR00341. Insert piston seal into groove on cylinder body.
2. With piston boot fitted to piston, insert piston boot into groove
on cylinder body and install piston.
3. Properly secure