2001 NISSAN ALMERA N16 Electronic Repair Manual

Page 401 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual 14 RESET THROTTLE POSITION SENSOR IDLE POSITION MEMORY
With CONSULT-II
NOTE:
Always warm up engine to normal operating temperature. If engine is cool, the throttle position sensor idle posi-
tion memo

Page 402 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual 15 CHECK THROTTLE POSITION SWITCH CLOSED POSITION-II
Without CONSULT-II
1. Disconnect closed throttle position switch harness connector.
2. Check continuity between closed throttle position switch ter

Page 403 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual 16 ADJUSTMENT THROTTLE POSITION SWITCH CLOSED POSITION-I
Without CONSULT-II
1. Loosen throttle position sensor fixing bolts.
2. Confirm that proper vacuum is applied. Refer to Test No. 10. During adju

Page 404 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual 17 ADJUSTMENT THROTTLE POSITION SWITCH CLOSED POSITION-II
Without CONSULT-II
1. Temporarily tighten sensor body fixing bolts as follows.
+Gradually move the sensor body clockwise and stop it when the

Page 405 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual 19 CHECK (1ST TRIP) DTC
1. Turn ignition switch ªOFFº.
2. Release vacuum from throttle opener.
3. Remove vacuum pump and vacuum hose from throttle opener.
4. Reinstall original vacuum hose to thrott

Page 406 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual 23 CHECK TARGET IDLE SPEED AGAIN
With CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Select ªENG SPEEDº in ªDATA MONITORº mode with CONSULT-II.
3. Check idle speed.

Page 407 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual 27 CHECK TARGET IDLE SPEED AGAIN
With CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Select ªENG SPEEDº in ªDATA MONITORº mode with CONSULT-II.
3. Check idle speed.

Page 408 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual 31 CHECK IGNITION TIMING
1. Start engine and let it idle.
2. Check ignition timing at idle using a timing light.
SEF984U
Ignition timing:
M/T 8ɱ5É BTDC
A/T 10ɱ5É BTDC (in ªPº or ªNº positi