2001 NISSAN ALMERA N16 Electronic Repair Manual

Page 1961 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual 3. Check weatherstrip visually for any damage, deterioration, or
flattening.
+If any damage is found, replace weatherstrip.
CAUTION:
Do not remove weatherstrip except when replacing, or filling
up but

Page 1962 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual SBF034BA
Removal and InstallationNJBT0023REMOVALNJBT0023S01After removing moldings, remove glass using piano wire or power
cutting tool and an inflatable pump bag.
WARNING:
When cutting the glass from

Page 1963 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual +Do not leave primers or adhesive cartridge unattended
with their caps open or off.
+The vehicle should not be driven for at least 24 hours or
until the urethane adhesive has completely cured. Curing

Page 1964 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual SIDE WINDOWNJBT0023S04
NBT067
WINDSHIELD AND WINDOWS
Removal and Installation (Contd)
BT-70

Page 1965 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual BACK DOOR WINDOWNJBT0023S05+Structure and removal/reinstallation method of back door win-
dow are basically the same as for the windshield.
NBT066
WINDSHIELD AND WINDOWS
Removal and Installation (Cont

Page 1966 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual Removal and InstallationNJBT0024CAUTION:
Be careful not to scratch door rearview mirror body.
HFor Wiring Diagram, refer to EL-167, ªDOOR MIRRORº for details.
1. Remove front corner of door inner co

Page 1967 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual Removal and InstallationNJBT0025REMOVALNJBT0025S01
NBT059
NBT206
INSTALLATIONNJBT0025S021. Install mirror base as follows:
a. Determine mirror base position on windshield by measuring
from top of wind

Page 1968 of 2493

NISSAN ALMERA N16 2001  Electronic Repair Manual AlignmentNJBT0026+All dimensions indicated in figures are actual ones.
+When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge
itself to make sure there i