Page 761 of 2572

HINT:
1) First wipe off any dirt, grease or oil with a rag soaked in a grease, wax and silicone remover.
2) Cover the surrounding areas with masking paper to avoid coating unnecessary areas. If other areas are acci-
dently coated, wipe off the coating immediately.
3) Apply the first coating of undercoat to all welded areas and panel joints, then apply a second coat over the
entire area.
4) Do not coat parts which become hot, such as the tailpipe, or moving parts, such as the propeller shaft.
5) Besides the locations described below, apply undercoating to all weld points under the body to insure corro-
sion prevention.
6) Be sure to seal the edge of the flange of the member and bracket with undercoating.
7) If undercoat is damaged by peeling, cracks, etc., be sure to repair as necessary.
8) Before the undercoat apply sealer allowing rust prevention to be attained.
F16736
REFERENCE
Referring to the notes above, undercoating should be applied according to the specifications for your country.
PAINT COATINGPC-6
BODY PANEL UNDERCOATING AREAS
Page 762 of 2572
HINT:
1) Whenever adjusting the doors and hoods, apply anti-rust agent (wax) around the hinges.
2) Even if partially repairing a part, apply anti-rust agent (wax) over the entire application area of the part.
3) Wipe off the anti-rust agent immediately with a rag soaked in a grease, wax and silicone remover, if accidently
applied to other areas.
F16738
PAINT COATINGPC-7
BODY PANEL ANTI-RUST AGENT (WAX) APPLICATION AREAS
Page 763 of 2572
F16740
HINT:
1) Anti-chipping paint should be applied to some areas before the second coat and to others after the top coat.
2) If other areas are accidentally coated, wipe of the paint immediately with a rag soaked in grease, wax and
silicone remover.
PVC Chipping Primer Urethane Primer Soft-Chip (Poly Olefine)
PAINT COATINGPC-10
BODY PANEL ANTI-CHIPPING PAINT APPLICATION AREAS
Page 764 of 2572
PAINT COATING
HINT:
1) Prior to applying body sealer, clean the area with a rag soaked in grease, wax and silicone remover.
2) If weld-through primer was used, first wipe off any excess and coat with anti-corrosion primer before applying
body sealer.
3) Wipe off excess body sealer with a rag soaked in a grease, wax and silicone remover.
4) If body sealer is damaged by peeling, cracks, etc., be sure to repair as necessary.
F16731
1. ENGINE COMPARTMENT
Flat FinishingNo Flat Finishing
PC-1
BODY PANEL SEALING AREAS
Page 765 of 2572
PAINT COATING
F16732
2. INSIDE PC-2
Page 766 of 2572
PAINT COATING
3. REAR LUGGAGE COMPARTMENT
F16733
PC-3
Page 767 of 2572
PAINT COATING
F16734
4. DOOR PARTS PC-4
Page 768 of 2572