2009 SUBARU TRIBECA Service Workshop Manual

trunk releaseMPGnight visionfuel fill door releasesport modehood release
Popular search:
odometercoolant capacitykeylessseatsconnectorRear diffself-diagnosis of combination meter
Previous
Next
Load previous 8 pages

Page 801 of 2453

SUBARU TRIBECA 2009 1.G Service Workshop Manual DI-17 Rear Differential (VA–type) DIFFERENTIALS 12) Tighten the self-locking nut. Tightening torque: 70 N·m (7.1 kgf-m, 51 ft-lb) 13) Lower the transmission jack. 14) Install the air breather hose

Page 802 of 2453

SUBARU TRIBECA 2009 1.G Service Workshop Manual DI-18 Rear Differential (VA–type) DIFFERENTIALS 9) Remove the bearing race from holder RH and LH with ST and press. ST 18758AA000 PULLER NOTE: •Make sure the bolt of puller turn manually.

Page 803 of 2453

SUBARU TRIBECA 2009 1.G Service Workshop Manual DI-19 Rear Differential (VA–type) DIFFERENTIALS 14) Extract the companion flange with a puller. 15) Removes the drive pinion shaft. 16) Remove the rear bearing cone from drive pin- ion by sup

Page 804 of 2453

SUBARU TRIBECA 2009 1.G Service Workshop Manual DI-20 Rear Differential (VA–type) DIFFERENTIALS 1) Adjusting preload for front and rear bearings Adjust the bearing preload between front and rear bearings with collar and washer. Pinion height ad-

Page 805 of 2453

SUBARU TRIBECA 2009 1.G Service Workshop Manual DI-21 Rear Differential (VA–type) DIFFERENTIALS Initial load: 12.7—32.2 N (1.3—3.28 kgf, 2.9—7.24 lb) Initial torque: 0.48 — 1.22 N·m (0.045—0.124 kgf-m, 0.32— 0.9 ft-lb) 2) Adjusting d

Page 806 of 2453

SUBARU TRIBECA 2009 1.G Service Workshop Manual DI-22 Rear Differential (VA–type) DIFFERENTIALS (3) Measure the clearance N between the end of ST2 and the end surface of ST1 by using a thickness gauge. NOTE: Make sure there is no

Page 807 of 2453

SUBARU TRIBECA 2009 1.G Service Workshop Manual DI-23 Rear Differential (VA–type) DIFFERENTIALS 6) Insert the collar, then install the pilot bearing. 7) Fit a new oil seal with ST. NOTE: •Press-fit until the oil seal end comes 1 mm (0.04 in) in

Page 808 of 2453

SUBARU TRIBECA 2009 1.G Service Workshop Manual DI-24 Rear Differential (VA–type) DIFFERENTIALS 12) Install the hypoid driven gear to differential case. NOTE: •Tighten diagonally while tapping the bolt heads. •Set a cushioning such as w
Load next 8 pages
Page:   < prev 1-10 ... 769-776 777-784 785-792 793-800 801-808 809-816 817-824 825-832 833-840 ... 2456 next >
beltgearboxfuel additivessteeringtrip computerfuse box
Popular search:
heatingdiagnostic menuB135 30automaticwindowfuel filter locationrear brake pads