2007 KIA CARNIVAL Workshop Manual

a.If the pad thickness is out of specilfication, left and right pads must be replaced as a complete set.
b. When the thickness difference between the left pad and right pad is large, check the sliding condition of
the piston and the guide rod.
INSPECTION OF REAR DISC BRAKE PAD
1.Check the rear disc brake pad thickness through the caliper body inspection hole.
Pad thickness
Standard value : 10.0 mm (0.39 in)
Service limit : 2.0 mm (0.0787 in)
a.If the pad thickness is out of specification, left and right pads must be replaced as a complete set.
b. When the thickness difference between the left pad and right pad is large, check the sliding condition of
the piston and the guide rod.

Brake Booster

2007 > 2.7L V6 GASOLINE >
COMPONENTS

2007 > 2.7L V6 GASOLINE >
Removal
1.Disconnect the vacuum hose (A) from the brake booster (B).
[LHD]
[RHD]
2.Remove the master cylinder (Refer to 'Master cylinder removal').
3. Remove the snap pin (A) and clevis pin (B).
4.Remove the four booster mounting nuts (C).
5. Remove the brake booster (A).

INSTALLATION
1.Adjust push rod length of the booster, and then install the seal on the booster assembly.
Standard length (A):
LHD : 112 ± 0.5 mm (4.43 ± 0.019 in.)
RHD : 115 ± 0.5 mm (4.53 ± 0.019 in.)
[LHD]
[RHD]
2.Insert the booster and tighten the nuts (C).

3.Connect the booster push rod and brake pedal with a pin (B) and install a snap clevis pin (A) to the clevis pin (B).
Grease the pin before installing the snap pin.
Always use a new snap pin.
4. Install the master cylinder.
5. Connect the vacuum hose to the brake booster.
6. After filling the brake reservoir with brake fluid, bleed the system (Refer to 'Bleeding of brake system',).
7. Check for fluid leakage.
8. Check and adjust the brake pedal for proper operation.

Master Cylinder

2007 > 2.7L V6 GASOLINE >
COMPONENTS