2007 KIA CARNIVAL Workshop Manual

2007 > 2.7L V6 GASOLINE >
COMPONENTS
COMPONENTS

COMPONENTS

2007 > 2.7L V6 GASOLINE >
REMOVAL
1.Raise the vehicle and remove the wheel & tire assembly (A) from the front hub assembly (B).
Tightening torque Nm (Kgf.m, lb - ft):
90 ~ 110 (9.0 ~ 11.0, 65 ~ 80)
2.Unstake the driveshaft lock nut using a chisel and hammer.
3.Remove the driveshaft lock nut (A).
Tightening torque Nm (Kgf.m, lb - ft):
245 ~ 275 (24.5 ~ 27.5, 177 ~ 199)

4.Remove the split pin and castle nut form the tie rod end ball joint.
Tightening torque Nm (Kgf.m, lb - ft):
60 ~ 80 (6.0 ~ 8.0, 43 ~ 58)
5.Disconnect the tie rod end (A) from the knuckle using a SST (09568- 4A000).
6.Remove the split pin and lower arm bolt and nut (A).
Tightening torque Nm (Kgf.m, lb - ft):
90 ~ 120 (9.0 ~ 12.0, 65 ~ 87)

7.Using a plastic hammer, disconnect the driveshaft (A) from the front hub assembly (B).
8.Removal of the driveshaft [RH].
a. [Gasoline 3.8 only]
Remove the heat protector (A).
b.Remove the inner shaft bearing bracket assembly mounting bolts (A).
Tightening torque Nm (Kgf.m, lb - ft):
Diesel: 43 ~ 63 (4.3 ~ 6.3, 31 ~ 46)

Gasoline: 50 ~ 65 (5.0 ~ 6.5, 36 ~ 47)
9.Insert pry bar (C) between the transaxle case (B) and driveshaft joint (A), separate driveshaft from the transaxle.
a.Use a pry bar being careful not to damage the transaxle and joint.
b. Do not insert a pry bar too deep, as this may cause damage to the oil seal.
c. Do not pry on the driveshaft by excessive force it may cause components inside the joint kit to dislodge
resulting in a torn boot or a damaged bearing.
10. Pull out the driveshaft from the transaxle case.
a.Plug the hole of the transaxle case with the oil seal cap to prevent contamination.
b. Replace the retainer ring whenever the driveshaft is removed from the transaxle case.
INSTALLATION
a.Replace the circlip with new ones before the installation.
b. Before the installation, apply the gear oil on the driveshaft splines (A) and contacting surface of differential
case oil seal (B).

1.Installation is reverse of the removal.
a.The driveshaft lock nut should be replaced with new ones.
b. After installation driveshaft lock nut, stake the lock nut using a chisel and hammer as shown in the
illustration below.
INSPECTION
1.Check the driveshaft boots for damage and deterioration.
2. Check the ball joints for wear and damage.
3. Check the splines for wear and damage.
4. Check the dynamic damper for cracks and wear.