2007 KIA CARNIVAL Workshop Manual

2007 > 2.7L V6 GASOLINE >
COMPONENTS

2007 > 2.7L V6 GASOLINE >
REMOVAL
a.Use a cover not to damage the vehicle surface.
b. Disconnect connectors carefully not to be damaged.
a.Mark wires or hoses for identification not to be confused.
1. Remove the battery(A).
2.After disconnecting the AFS connector(A) and removing the alr cleaner upper body(B) taka the air cleaner filter out
of the air cleaner under body.
3.Remove the air cleaner assembly (B) by removing the two mounting bolts(A).
4.Remove the battery tray(B) by removing the four mounting bolts(A).

5.Disconnect the vehicle speed sensor connector (A) and the back up lamp switch(B).
6.Disconnect the shift cable assembly(A) after remaing the clips(B) and pins(C).
7.Remove the wire harness bracket(A).

8.Remove C.S.C (Concentric Slave Cylinder) tube(A) which is being clamped by loosening the nut(B).
9.Remove the transaxle upper mounting bolts(A).
10. Support the engine and transaxle by using the special tool (09200- 38001).

11.Remove the transaxle insulator bracket (B) by removing the bolts (A).
12.Remove the front wheels and tires. (see SS group)
13. Lift up the vehicle.
14. Remove the steering column joint bolt. (see ST group).
15. Remove the under cover(A).
16.Drain power steering oil through the return tube(A). (see ST group)

17.Disconnect the power steering pressure hose (A) from the power steering oil pump. (see ST group)
18.Drain the tranaxle fluid through the drain plug.
19. Remove the hanger(A).
20.Disconnect the lower arm, the tie rod end ball joint, the stabilizer bar link from the front knuckle. (see SS group)
21. Remove the roll stopper mounting bolt(A).
22.Remove the power steering return tube mounting bolt(A)

23.Remove the rear roll stopper mounting bolts(A).
24.Disconnect the VRS connector(A). (see ST group)
25.Remove the mounting bolts from the sub frame by supporting the sub frame(A) with a jack. (see SS group)
26.Remove the exhaust pipe(A).

27.Remove the inner shaft bracket mounting bolt(A). RH
28.Remove the drive shafts(A) from the transaxle. (see DS group)
29.Remove the side cover(A).