Page 753 of 1575
2007 > 2.7L V6 GASOLINE >
INSPECTION
1.Ignition "ON".
2. Manually operate the control switch and measure the voltage of blower motor between pin 1 and 2.
3. Select the control switch to raise voltage until high speed.
Fan Voltage
Manual
1 STEP 4.5 ± 0.5V
2 STEP 5.7 ± 0.5V
3 STEP 6.9 ± 0.5V
4 STEP 8.1 ± 0.5V
5 STEP 9.3 ± 0.5V
6 STEP 10.3 ± 0.5V
7 STEP Battary(+)
REPLACEMENT
1.Disconnect the negative ( - ) battery terminal.
2. Remove the luggage side trim (Refer to BD - ).
3. Disconnect the power mosfet connector (A).
4. Remove the power mosfet (B) after loosening the mounting screws.
Page 754 of 1575
Page 755 of 1575
2007 > 2.7L V6 GASOLINE >
COMPONENT
1 Tail lamp (ILL+)
2 IGN 2
3 Rear temp S/W
4 Rear temp S/W (VENT)
5 Rear temp S/W (B/L)
Page 756 of 1575
6Rear temp S/W (FLOOR)
7 Rhostat (ILL- )
8 Sensor Ref (+5V)
9 Sensor ground
10 Rear mode IND (VENT)
11 Rear mode IND (B/L)
12 Rear mode IND (FLOOR)
13 GND
14 -
15 -
16 Rear blower S/W
Page 757 of 1575
2007 > 2.7L V6 GASOLINE >
REPLACEMENT
1.Remove the rear control panel(A) and then dissconnect the rear control panel connector(B).
2.Installation is the reverse order of removal.
Page 758 of 1575
Page 759 of 1575
Page 760 of 1575
2007 > 2.7L V6 GASOLINE >
COMPONENT LOCATION
COMPONENTS