2007 KIA CARNIVAL Workshop Manual

Tightening torque Nm (kgf.m, lb - ft) :
13 ~ 18 (1.3 ~ 1.8, 9.4 ~ 13.0)
After installation, if neccessary, adjust the alignment of the steering wheel and front tires
INSPECTION
1.Check the bushing for wear and deterioration.
2. Check the stabilizer bar for bending or breakage.
3. Check the ball joint for rotating torque.
(1) If there is a crack in the dust cover, replace it and add grease.
(2) Move the stabilizer link ball joint stud several times in a circular motion.
(3) Mount the self - locking nut on the ball joint, and then measure the ball joint rotating torque.
Standard value :
0.5 ~ 2.5 Nm (5 ~ 25 kgf., 0.36 ~ 1.81 lb - ft)
Measure torque using the special tool(09532- 11600) and torque wrench at the range of 0.5 - 2 rpm after
moving the ball joint stud 10 times at room temperature.
(4)If the rotating torque exceeds the upper limit of standard value, replace the upper arm assembly.
(5) Even if the rotating torque is below the lower limit of the standard value, the ball joint may be reused unless it
has drag and excessive play.

Rear Suspension System

2007 > 2.7L V6 GASOLINE >
COMPONENTS

Rear Shock Absorber

2007 > 2.7L V6 GASOLINE >
COMPONENTS

2007 > 2.7L V6 GASOLINE >
REMOVAL
1.Loosen the wheel nuts slightly.
Raise the rear of the vehicle, and make sure it is securely supported.
2. Remove the rear wheel and tire (A) from rear hub (B).
Be careful not to damage the hub bolts (C) when removing the rear wheel and tire (A).
3. Remove the rear shock absorber assembly mounting bolts (A) and nut (B) from the baby.
4.Remove the rear shock absorber assembly nut (B) from the rear knuckle, then remove the shock absorber
assembly (A).
5.Remove the rear shock absorber bracket bolt (A).

INSTALLATION
1.Install the connecting bolt (A) between the rear shock absorber and the bracket.
Tightening torque Nm(kgf.m, lb - ft) :
160 ~ 180 (16 ~ 18, 115.7 ~ 130.2)
2.Install the rear shock absorber (A) to the knuckle temporarily.
3.Install the rear shock absorber bracket mounting bolts (A) and nut (B).
Tightening torque Nm(kgf.m, lb - ft) :
Bolt : 80 ~ 110 (8 ~ 11, 59.7 ~ 79.5)
Nut : 90 ~ 120 (9 ~ 12, 65.1 ~ 86.8)

4.Install the rear shock absorber (A) nut (B) to the knuckle.
Tightening torque Nm(kgf.m, lb - ft) :
160 ~ 180 (16 ~ 18, 115.7 ~ 130.2)
5.Install the wheel and the tire (A) to the rear hub (B).
Tightening torque Nm (kgf.m, lb - ft) :
90 ~ 110 (9 ~ 11, 65.1 ~ 79.5)
Be careful not to damage the hub bolts (C) when installing the rear wheel and tire (A).
INSPECTION
1.Check the rubber parts for damage or deterioration.
2. Check the shock absorber for abnormal resistance or unusual sounds.