2011 NISSAN LATIO Service Repair Manual

Page 2809 of 3787

NISSAN LATIO 2011  Service Repair Manual REAR WINDOW DEFOGGERGW-55
< SERVICE INFORMATION >
C
DE
F
G H
J
K L
M A
B
GW
N
O P
Terminal and Reference Value for BCMINFOID:0000000005929501
Refer to  BCS-12, "Terminal and Reference Value for BCM" .

Page 2810 of 3787

NISSAN LATIO 2011  Service Repair Manual GW-56
< SERVICE INFORMATION >
REAR WINDOW DEFOGGER
BCM Power Supply and Ground Circuit Inspection
INFOID:0000000005929506
Refer to  BCS-16, "BCM Power Supply and Ground Circuit Inspection" .
Rear Wind

Page 2811 of 3787

NISSAN LATIO 2011  Service Repair Manual REAR WINDOW DEFOGGERGW-57
< SERVICE INFORMATION >
C
DE
F
G H
J
K L
M A
B
GW
N
O P
1. Turn ignition switch OFF.
2. Disconnect BCM and front air control.
3. Check continuity between BCM connector M18 (A

Page 2812 of 3787

NISSAN LATIO 2011  Service Repair Manual GW-58
< SERVICE INFORMATION >
REAR WINDOW DEFOGGER
OK or NG
OK >> GO TO 2.
NG >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
2.CHECK REAR WINDOW DEFOGGER PO

Page 2813 of 3787

NISSAN LATIO 2011  Service Repair Manual REAR WINDOW DEFOGGERGW-59
< SERVICE INFORMATION >
C
DE
F
G H
J
K L
M A
B
GW
N
O P
OK or NG
OK >> GO TO 5.
NG >> Repair or replace harness.
5.CHECK CONDENSER-1
Check continuity between condenser-1 term

Page 2814 of 3787

NISSAN LATIO 2011  Service Repair Manual GW-60
< SERVICE INFORMATION >
REAR WINDOW DEFOGGER
OK or NG
OK >> Check condition of harness and connector.
NG >> Replace IPDM E/R. Refer to PG-28, "
Removal and Installation of IPDM E/R" .
Door Mirro

Page 2815 of 3787

NISSAN LATIO 2011  Service Repair Manual REAR WINDOW DEFOGGERGW-61
< SERVICE INFORMATION >
C
DE
F
G H
J
K L
M A
B
GW
N
O P
1. Disconnect door mirror (LH or RH).
2. Check continuity between door mirror (LH or RH) connector and heated mirror r

Page 2816 of 3787

NISSAN LATIO 2011  Service Repair Manual GW-62
< SERVICE INFORMATION >
REAR WINDOW DEFOGGER
2. Attach probe circuit tester (in Volt range) to middle portion ofeach filament.
3. If a filament is burned out, circuit tester registers 0 or batte