2001 INFINITI QX4 Factory Service Manual

widthtrailermirror controlsfuel filterload capacityspark plugs
Popular search:
oil dipstickwarning lightswheel sizeseat memoryad blueAc systemP0171
Previous
Next
Load previous 8 pages

Page 113 of 2395

INFINITI QX4 2001 Factory Service Manual Diagnostic ProcedureNBAT0032 1 INSPECTION START Do you have CONSULT-II? YesorNo Ye s©GO TO 2. No©GO TO 6. 2 CHECK INPUT SIGNAL OF A/T FLUID TEMPERATURE SENSOR (WITH CONSULT-II) With CONSULT-II 1. St

Page 114 of 2395

INFINITI QX4 2001 Factory Service Manual 4 CHECK A/T FLUID TEMPERATURE SENSOR WITH TERMINAL CORD ASSEMBLY 1. Turn ignition switch to ªOFFº position. 2. Disconnect terminal cord assembly connector on the right side of transfer assmebly. 3.

Page 115 of 2395

INFINITI QX4 2001 Factory Service Manual 7 CHECK DTC Perform Diagnostic Trouble Code (DTC) confirmation procedure, AT-106. OK or NG OK©INSPECTION END NG©GO TO 8. 8 CHECK TCM INSPECTION 1. Perform TCM input/output signal inspection. 2. If N

Page 116 of 2395

INFINITI QX4 2001 Factory Service Manual SAT136K DescriptionNBAT0034The revolution sensor detects the revolution of the out put shaft parking pawl lock gear and emits a pulse signal. The pulse signal is sent to the TCM which converts it into

Page 117 of 2395

INFINITI QX4 2001 Factory Service Manual SAT014K SAT971J SAT014K SAT020K DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE NBAT0034S01CAUTION: IAlways drive vehicle at a safe speed. IBe careful not to rev engine into the red zone on the t

Page 118 of 2395

INFINITI QX4 2001 Factory Service Manual Wiring Diagram Ð AT Ð VSSA/TNBAT0188 MAT910A GI MA EM LC EC FE TF PD AX SU BR ST RS BT HA SC EL IDX DTC P0720 VEHICLE SPEED SENSOR´A/T (REVOLUTION SENSOR) Wiring Diagram Ð AT Ð VSSA/T AT-113

Page 119 of 2395

INFINITI QX4 2001 Factory Service Manual Diagnostic ProcedureNBAT0035 1 INSPECTION START Do you have CONSULT-II? YesorNo Yes (With CONSULT-II)©GO TO 2. No (Without CONSULT- II)©GO TO 5. 2 CHECK INPUT SIGNAL (WITH CONSULT-II) With CONSULT-I

Page 120 of 2395

INFINITI QX4 2001 Factory Service Manual 5 CHECK INPUT SIGNAL (WITHOUT CONSULT-II) Without CONSULT-II 1. Start engine. 2. Check voltage between TCM terminal 29 and ground while driving. (Measure with AC range.) Voltage: At 0 km/h (0 MPH): 0V
Load next 8 pages
Page:   < prev 1-10 ... 81-88 89-96 97-104 105-112 113-120 121-128 129-136 137-144 145-152 ... 2400 next >
trailerUSB portlanguagewiring diagramtransmission oiltraction control
Popular search:
engine coolanttire pressurealternator replacefuel cap releasestarterfuse diagramlow oil pressure